Trane Series R Helical Rotary Rtac Installation And Maintenance Manual SVX01M EN (01/2015)

2015-04-02

• Introduction
• Table of Contents
• Model Number Description
  • Outdoor Unit Nameplate
  • Compressor Nameplate
• Model Number Descriptions
  • Unit Model Number
  • Compressor Model Number
  • Compressor Serial Number
• General Data
  • Unit Description
  • Accessory/Option Information
    • Isolator Shipping Location
• Pre-installation
  • Unit Inspection
  • Inspection Checklist
  • Storage
  • Installation Responsibilities
  • General
• Dimensions and Weights
  • Dimensions
  • Clearances
  • Weights
    • Non-Seismically Rated Units
    • Seismically Rated Unit Weights
    • Remote Evaporator Unit Weights
• Installation - Mechanical
  • Location Requirements
    • Noise Considerations
    • Foundation
    • Clearances
  • Rigging
    • Lifting Procedure
  • Isolation and Sound Emission
  • Mounting and Leveling
  • Unit Isolation
    • Elastomeric Isolators (Optional for units without seismic rating)
    • Unit Isolation for Seismically Rated Units
    • Isolator Selection and Mounting Locations
  • Drainage
  • Evaporator Water Piping
    • Entering Chilled Water Piping
    • Leaving Chilled Water Piping
    • Evaporator Drain
    • Evaporator Flow Switch
  • Water Pressure Gauges
  • Water Pressure Relief Valves
  • Freeze Avoidance
  • Low Evaporator Refrigerant Cutout, Glycol Recommendations
    • Procedure
    • Specials
• Installation - Mechanical Remote Evaporator Option
  • System Configuration and Interconnecting Refrigerant Piping
  • Line Sizing
    • Liquid Line Sizing Steps
    • Suction Line Sizing Steps
    • Suction Accumulator Sizing
  • Piping Installation Procedures
  • Refrigerant Sensors
  • Refrigerant Pressure Relief Valve Venting
  • Leak Test and Evacuation
  • Refrigerant and Additional Oil Charge
    • Refrigerant Charge Determination
    • Oil Charge Determination
• Installation - Electrical
  • General Recommendations
  • Installer-Supplied Components
    • Power Supply Wiring
  • Control Power Supply
    • Heater Power Supply and Convenience Outlet (Packaged Units Only)
  • Interconnecting Wiring
    • Chilled Water Pump Control
  • Alarm and Status Relay Outputs (Programmable Relays)
  • Relay Assignments Using TechView
  • Low Voltage Wiring
    • Emergency Stop
    • External Auto/Stop
    • External Circuit Lockout – Circuit #1 and #2
    • Ice Building Option
    • External Chilled Water Setpoint (ECWS) Option
    • External Current Limit Setpoint (ECLS) Option
    • Chilled Water Reset (CWR)
  • Communications Interface Options
    • Tracer Communications Interface Option
    • LonTalk™ Interface (LCI-C)
• Operating Principles
  • Refrigeration Cycle
  • Refrigerant R-134a
  • Compressor
  • Condenser and Subcooler
  • Expansion Valve
  • Evaporator
  • Oil System
• Controls Interface
  • Overview
  • Controls Interface
  • DynaView Display
    • Key Functions
    • Display Screens
    • Modes Screen
    • Chiller Screen
    • Compressor Screen
    • Refrigerant Screen
    • Setpoint Screen
    • Diagnostic Screen
    • Power-Up
  • Display Formats
    • Units
    • Languages
  • TechView
    • Unit View
    • Compressor Service View
    • Status View
    • Setpoint View
    • Diagnostics View
    • Configuration View
    • Software View
    • Binding View
    • Replacing or Adding Devices
• Pre-Start Checkout
• Start-Up and Shutdown
  • Unit Start-Up
  • Temporary Shutdown and Restart
  • Extended Shutdown Procedure
  • Seasonal Unit Start-Up Procedure
  • System Restart After Extended Shutdown
  • Sequence of Operation
• Maintenance
  • Weekly
  • Monthly
  • Annual
  • Refrigerant and Oil Charge Management
  • Lubrication System
    • Oil Sump Level Check
  • Condenser Maintenance
    • Condenser Coil Cleaning
  • Travel Restraint
• Diagnostics
  • Legend to Diagnostics Table
  • Starter Diagnostics
  • Main Processor Diagnostics
  • Communication Diagnostics
  • Main Processor Boot Messages and Diagnostics
• Unit Wiring
• Log and Check Sheet