TransCore 05846 LOW POWER TRANSMITTER (2400-2483.5 MHz) User Manual
TransCore LOW POWER TRANSMITTER (2400-2483.5 MHz)
User Manual
ROVR SIDEKICK™ Installation and Operation This document describes how to correctly install a ROVR SIDEKICK™ device. The ROVR SIDEKICK is used with the ROVR™ vehicle tracking unit for convenience in viewing toll rates and paying for HOT lane use. These instructions cover what you need to know to get your ROVR Sidekick up and running: • Battery Installation • Sidekick Unit Installation • Operation Battery Installation The Sidekick requires 2 AAA batteries for operation. Non-rechargeable lithium batteries are recommended for maximum life. Some high capacity alkaline batteries will also be sufficient but have shorter lifetimes. The Sidekick has a battery compartment. Batteries are inserted in-line to the compartment through a small door on the side of the unit. Open the door by removing the attached thumbscrew. Battery compartment Thumbscrew Door (removed) Insert both batteries negative (-) terminal first. The top of the batteries will protrude from the opening. ROVR SIDEKICK Installation and Operation v1.0 | Document Number 412158 Page 1 of 6 3 Manipulate the battery tab opposite the thumbscrew into the opening and screw the door back in. This requires a small amount of force to overcome the internal battery spring. Thumbscrew Battery tab When the door is fully in place, the display should light with a message that reads ROVR SIDEKICK, along with a version number. ROVR SIDEKICK Installation and Operation v1.0 | Document Number 412158 ROVR SIDEKICK VERSION X.X Page 2 of 6 Sidekick Unit Installation Your ROVR Sidekick kit includes the necessary parts to attach the unit to: • the vehicle visor with a clip, or to • the windshield with either double-sided adhesive or suction cups. Visor Mount Clip Windshield Mount Adhesive Suction Cups ROVR SIDEKICK Installation and Operation v1.0 | Document Number 412158 Page 3 of 6 Operation The ROVR Sidekick has two “rocker” switches, one on each side, that allow you to power the unit on and off, select the number of occupants in your vehicle, and choose to use a HOT lane payment. Each switch has 3 positions: Up, Center, and Down. When you press the switch, it rocks to the position you choose and then returns to center. A display on the ROVR Sidekick shows messages. Select the number of people in your vehicle: Choose HOT Lane use: Toll Selection Switch Occupancy Switch Up: Use HOT lane & pay toll Center: See toll only–don’t use HOT yet Up: 1 person in vehicle Screen displays messages here Center: 2 people in vehicle Down: Turn ON or see last message. Press and hold to turn OFF. Down: 3+ people in vehicle Turn On the ROVR Sidekick Press PWR/Display. The ROVR Sidekick display shows this message on power-up: NO TOLL INFO Set Number of Occupants If it will be just you in the vehicle, select 1 (Up) with the Occupancy Switch. 1 PERSON For two passengers, select 2 (Center) with the Occupancy Switch. 2 PEOPLE For three passengers, select 3 (Down) with the Occupancy Switch. 3 PEOPLE ROVR SIDEKICK Installation and Operation v1.0 | Document Number 412158 Page 4 of 6 Use the HOT Lane Make sure you have selected the correct number of occupants. 2 PEOPLE Enter Pre-Toll Geo-zone. Choose DISPLAY TOLL (Center) –or- press PWR/DISPLAY (Down). The ROVR Sidekick shows the toll amount. Continue current route towards the HOT Lane. HOT LANE AHEAD TOLL $2.34 Press PAY TOLL (Up). The ROVR Sidekick confirms your choice. Enter Toll area. You are charged according to your occupancy setting: ALLOW CHARGES 2 PEOPLE HOT LANE ENTRY PAID $2.34 Check Toll but Skip the HOT Lane Make sure you have selected the correct number of occupants. Enter Pre-Toll area. Choose DISPLAY TOLL – or- press PWR/DISPLAY. The ROVR Sidekick confirms the command. The ROVR Sidekick shows the toll amount. If you decide you don’t want to use the HOT lane and pay the toll, do not enter the Toll Geo-zone. ROVR SIDEKICK Installation and Operation v1.0 | Document Number 412158 2 PEOPLE DO NOT USE HOT DISPLAY TOLL ONLY HOT LANE AHEAD TOLL $2.34 Page 5 of 6 Turn Off the ROVR Sidekick Press and hold PWR/DISPLAY for 2.5 seconds. This message flashes before the ROVR Sidekick powers off: TURNING OFF Regulatory and Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The Sidekick™ may not be modified, altered, or changed in any way without permission from TransCore, LP. Unauthorized modification may void the equipment authorization from the FCC and will void the TransCore warranty. www.transcore.com ©2012 TC License, Ltd. All rights reserved. TRANSCORE is a registered trademark and is used under license. ROVR is a trademark of TransCore and Cartasite. ROVR SIDEKICK is a trademark of TransCore. All other trademarks listed are the property of their respective owners. Contents subject to change. Printed in the U.S.A.. ATIONS ROVR SIDEKICK Installation and Operation v1.0 | Document Number 412158 Page 6 of 6
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Create Date : 2012:12:12 10:16:43-07:00 Creator Tool : PScript5.dll Version 5.2.2 Modify Date : 2012:12:12 10:16:43-07:00 Producer : Acrobat Distiller 10.1.4 (Windows) Format : application/pdf Title : Microsoft Word - Sidekick Install&UserInstructions_v1.0_5__working.docx Creator : HHastings Document ID : uuid:6063737f-6ace-44ba-b693-339a05e04c95 Instance ID : uuid:7c5d3e58-2a54-4568-8d2b-6d2a76087b94 Page Count : 6 Author : HHastingsEXIF Metadata provided by EXIF.tools