Triamp Technology BLUETOOTH Bluetooth Car Kit User Manual Installation Guide draft4 b

Triamp Technology., Ltd. Bluetooth Car Kit Installation Guide draft4 b

Contents

Installatio manual

This quick guide demonstrates how to set up and install the Bluetooth Wireless Car Kit into a vehicle. For
more detailed information about the use and functions of this device, refer to the user’s manual.
Identifying Components
Unpack the Car Kit package and check it contains the following components.
• One junction box
• One control module
• One multi-directional microphone
• One speaker with mounting bracket
• One set of power cables
If any items are missing or damaged, contact your dealer.
A. Installing the Junction Box
The Car Kit is designed to work with the 12-volt power supply of the vehicle. Refer to the following to install
the junction box in a vehicle.
1. Locate a suitable place inside the car to mount the junction box. Select a dry place that avoids
excessive heat and mechanical vibration. Ideally, the junction box should be hidden from view,
but still easily accessible.
Note: Make sure that the cables are long enough to support the location of the junction box. If
the cables are not long enough, do not lengthen the cables; relocate the junction box.
2. Use two screws (not included) to fasten the junction box in place.
B. Connecting the Power Supply
The following illustration demonstrates how to connect the Car Kit’s power cables to the vehicle’s
electrical system.
GND
Power cables
To car radio
mute (PNP 300mA)
Yellow cable
To battery + 12V
Red cable
To ignition
Blue cable
Black cable
2
Important!
The Blue cable must be connected to the 12V switched to enable the Car Kit to go into standby mode.
Do not connect the Blue cable to the +12V permanent. Doing so may discharge the battery of the
vehicle and prevent the Car Kit from being reset.
C. Connecting Accessories
The following illustration shows where to connect accessory devices.
Control module
Speaker
Microphone
Junction box
Control module The control module should be located within reach and view of the
driver.
Speaker For best reception, the speaker should be mounted at least 80 cm (30
inches) from the Car Kit’s microphone.
Microphone Ideally, the microphone should be located in front of the user and
above waist height.
D. Installing the microphone
Before installing the microphone, take note of the following:
• Make sure that the cable can reach from the microphone to the speaker. If the cable is
too short, relocate the microphone. Do not lengthen the cable.
• The supplied microphone is uni-directional. For best results, place the microphone in
front of the person talking. It has a reception angle of 60 degrees, and is most effective
within a 60 cm radius.
Using the microphone stand
Find a suitable place for the microphone stand. Remove dust and grease from the surface.
1. Remove the protective cover from one
side of the double-sided tape and
press it firmly onto the bottom of the
stand.
3
2. Remove the other protective cover,
and firmly press the stand in place.
3. Push the microphone into the stand.
Using the microphone visor clip
1. Slide the visor clip onto the visor with
the microphone clip facing down.
2. Push the microphone into the
mounting clip.
Upgrading Firmware (optional)
It may be possible to use future phone models by upgrading the firmware in the Car Kit. Firmware is
upgraded via the serial port located on the back of the junction box.
Serial port
When upgrading, follow the installation instructions that are provided with the firmware upgrade.

Navigation menu