Tunstall Healthcare 4100426 Wireless Keypad 41004/26 User Manual Manual

Tunstall Healthcare (UK) Limited Wireless Keypad 41004/26 Manual

Manual

 D4107132A   © Tunstall Wireless Keypad User Guide   On each key press, the keypad will beep and the Green LED will blink. When a correct sequence is keyed in, the keypad  will chirp and flash the green LED.  Arming or Disarming the Intruder monitoring feature  To arm both zones 1 and  2, enter your 4 digit Security  PIN and then press  To arm Zone 1 only (partial arm), enter your 4 digit Security PIN and then press  To disarm the feature, enter your 4 digit Security PIN and then press   Panic Alarm To activate a Panic or Bogus caller alarm, press and hold the “SOS” button for 2 seconds.   Indicating Caregiver arrived  To indicate Caregiver Arrived, the caregiver should enter the 4 digit caregiver PIN and then press   Assigning a new PIN A new keypad will have the following default PIN numbers:       Security PIN ‘0000’               Caregiver PIN ‘0000’ To assign a new Security PIN, press and hold “S”. Press 1 then enter your existing 4 digit PIN. Enter a new 4 digit PIN then release “S” after the keypad beeps   To assign a Caregiver PIN, press and hold “S”. Press 2 then enter the existing 4 digit PIN. Enter a new 4 digit PIN  then release “S” after the keypad beeps
 D4107132A   © Tunstall   Cleaning and maintenance  Dust the Keypad with a soft cloth which can be moistened with a gentle detergent if required. Ensure no moisture goes behind the keypad.  Battery Information  Typical battery life is 5 years.  Your keypad will self report a low battery condition to your monitoring service.   The replacement battery type is a 3 volt Lithium battery, number CR123A. The battery and fitting instructions can be obtained from your monitoring service. Supplier Contact: FCC Notice  Wireless Keypad (Part Number 41004/26) FCCID: G2X-4100426 This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions: (1)  This device may not cause harmful interference, and (2)  This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

Navigation menu