Tunstall Healthcare 4100426 Wireless Keypad 41004/26 User Manual Manual
Tunstall Healthcare (UK) Limited Wireless Keypad 41004/26 Manual
Manual
D4107132A © Tunstall
Wireless Keypad User Guide
On each key press, the keypad will beep and the Green LED will blink.
When a correct sequence is keyed in, the keypad will chirp and flash
the green LED.
Arming or Disarming the Intruder monitoring feature
To arm both zones 1 and 2, enter your 4 digit Security
PIN and then press
To arm Zone 1 only (partial arm), enter your 4 digit
Security PIN and then press
To disarm the feature, enter your 4 digit Security PIN
and then press
Panic Alarm
To activate a Panic or Bogus caller alarm, press and
hold the “SOS” button for 2 seconds.
Indicating Caregiver arrived
To indicate Caregiver Arrived, the caregiver should enter
the 4 digit caregiver PIN and then press
Assigning a new PIN A new keypad will have the following default PIN
numbers: Security PIN ‘0000’ Caregiver PIN ‘0000’
To assign a new Security PIN, press and hold “S”.
Press 1 then enter your existing 4 digit PIN. Enter a new
4 digit PIN then release “S” after the keypad beeps
To assign a Caregiver PIN, press and hold “S”.
Press 2 then enter the existing 4 digit PIN. Enter a new 4
digit PIN then release “S” after the keypad beeps
D4107132A © Tunstall
Cleaning and maintenance
Dust the Keypad with a soft cloth which can be moistened with a gentle
detergent if required. Ensure no moisture goes behind the keypad.
Battery Information
Typical battery life is 5 years. Your keypad will self report a low battery
condition to your monitoring service.
The replacement battery type is a 3 volt Lithium battery, number
CR123A. The battery and fitting instructions can be obtained from your
monitoring service.
Supplier Contact:
FCC Notice
Wireless Keypad (Part Number 41004/26)
FCCID: G2X-4100426
This device complies with Part 15 of the FCC Rules
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment