Visteon TX9 Transmitter for Remote Keyless Entry System User Manual
Visteon Corporation Transmitter for Remote Keyless Entry System
Visteon >
User Manual
Using the remote control 4. 5. 6. 7. USING THE REMOTE CONTROL Remote control WARNING Approach lighting. Emergency alarm. Key blade release tab. Key blade. FCC and Canadian warning statement Never leave the remote control in the vehicle if children or animals are also left in the vehicle. The vehicle's systems and remote control functions could be operated, which may result in injury. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. Note: The operational range of the remote control will vary considerably depending on atmospheric conditions and interference from other transmitting devices. The vehicle is supplied with two remote controls, but up to six can be programmed to the vehicle at any one time. Any changes or modifications not expressly approved by the party responsible for compliance could void the userâs authority to operate the equipment. This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must accept any interference, including interference that may cause undesired operation of the device. Transmitter FCC ID: NT8-TX9 IC : 3043A-TX9 1. Unlock. 2. Lock. 3. Tailgate release. Using the remote control Unlocking Automatic relocking Press briefly to unlock the vehicle, and deactivate the alarm. The hazard warning lamps will flash twice to indicate that the vehicle is unlocked and the alarm has been deactivated. The interior lamps will illuminate to assist entry to the vehicle. If a door, or the tailgate, are not opened within one minute of unlocking the vehicle, doors will lock again automatically. Approach lighting When approaching the vehicle during darkness press to switch on the approach illumination. Press again to turn the approach lamps off. Single/Multi-point entry When you press the unlock button your vehicle will unlock in one of two ways: The approach illumination period set at the factory is thirty seconds. This can be configured by a Land Rover Dealer to provide illumination lasting between Zero and 120 seconds. 1. Unlock the driver's door only. A second press is required to unlock the remaining doors and tailgate. 2. Unlock all doors, and the tailgate. This security feature unlocks only the driverâs door and tailgate. It can be disabled on individual remote controls by unlocking the vehicle then simultaneously pressing and holding the lock and unlock buttons for three seconds. The vehicle will lock and then unlock in the currently selected mode and the hazard warning lights will flash twice to confirm the change. You can now unlock all doors with a single press. Repeating the procedure will re-enable Single point entry. Tailgate Press briefly to release the tailgate. Emergency alarm Press and hold for three seconds, or press twice within three seconds, to activate the horn and the hazard lamps. Once active for more than five seconds the alarm can be cancelled by pressing the button and holding for three seconds, or pressing twice within three seconds. Locking Press briefly to lock the vehicle, and activate the alarm. The hazard warning lamps will flash to indicate that the vehicle is locked. Note: The horn and hazard lamps will switch off automatically after two minutes and forty five seconds. Using the remote control Remote battery The remote control batteries are recharged when the remote is docked and the engine is running. For this reason it is recommended that each remote is used periodically. This will ensure that the batteries are kept charged and ready for use.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Page Mode : UseOutlines XMP Toolkit : 3.1-701 Create Date : 2006:11:02 13:19:39Z Creator Tool : Unknown Modify Date : 2006:11:02 13:35:19Z Metadata Date : 2006:11:02 13:35:19Z Format : application/pdf Creator : Unknown Title : Untitled Producer : XEP 4.3 build 20050518 Trapped : False Document ID : uuid:d46ad8b0-69f7-443b-898e-fb2b40d24e67 Instance ID : uuid:f38571aa-78e1-4a8d-89d3-5d9f878d4fc2 Page Count : 3 Author : UnknownEXIF Metadata provided by EXIF.tools