Wave Wireless Networking SL9101A Spread Spectrum Transmitter User Manual USERS MANUAL 3

USERS MANUAL 3

SPEEDLAN 9000 Series Installation and Operation User Guide Version

Regulations (Appendix D)- 3

Manufacturer Information

Manufacturer/Importer Name: Wave Wireless Networking

A Division of SPEEDCOM Wireless Corporation

7020 Professional Parkway East

Sarasota, FL 34240

Phone: 941-907-2300

Fax: 941-355-0219

Regulatory Information

Install this device in accordance with the instructions provided in this User Guide. To

determine the type of device you should use in your country, see the Radio Approval

Table on page 6 of this section.

Manufacturers Federal Communication Commission

Declaration of Conformity Statement

This equipment has been tested and found to comply with the limits of a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in

a residential environment. This equipment generates, uses, and radiates radio

frequency energy, and if not installed and used in accordance with the instructions,

may cause harmful interference. However, there is no guarantee that interference will

not occur. If this equipment does cause interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged

to correct the interference by one of the following measures:

•Reorient or relocate the receiving antenna.

•Increase separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from which the

receiver is connected.

•Consult the professional installer or an experienced radio/TV technician.

Note: The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modifications to this equipment. Such modifications could void the user’s

authority to operate the equipment.