User Manual
Wistron Corporation PRODUCT SPECIFICATION MODEL BlueSlim2 PRODUCT DESCRIPTION Bluetooth USB module compliant with BT 2.1+EDR / 3.0+HS / 4.0 and LE TYPE 6pin connector DIMENSION 6.5mm*30mm*2mm MAIN CHIPSET CSR8510A10 Revision: V0.93 CONFIDENTIAL REVISION HISTORY Revision Issue Date Change Note 0.90 Aug.28, 2014 Preliminary release 0.91 Sep.01, 2014 Correct Chapter 3.4 pin assignment: pin5,6 are unused. 0.92 Mar.19, 2015 Correct QâTY/TRAY. 0.93 Jan.23, 2017 Add Halogen free/ROHS compliance. Software ver: to be confirmed. COPYRIGHT Š 2014 Wistron Corporation, ALL RIGHTS RESERVED. TABLE OF CONTENTS 1. INTRODUCTION 1.1 APPEARANCE 1.2 BLOCK DIAGRAM 2. FEATURES 3. SPECIFICATIONS 4. 3.1 GENERAL SPECIFICATIONS 3.2 ELECTRICAL CHARACTERISTICS 3.3 POWER MEASUREMENT 3.4 MODULE PIN ASSIGNMENT 3.5 Module Dimension 3.6 ENVIRONMENTAL 3.7 SOFTWARE 3.8 FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT PACKAGE COPYRIGHT Š 2014 Wistron Corporation, ALL RIGHTS RESERVED. 1. INTRODUCTION BlueSlim2 is a USB Bluetooth module from official CSR reference design; it is fully compatible with the Bluetooth v3.0 + High Speed and Bluetooth v4.0 standards, offering high-speed data transfer and Bluetooth low energy for PC products. Through products based on BlueSlim2, consumers can take full advantage of the Bluetooth low energy ecosphere, connecting peripherals such as mice and keyboards and benefiting from Bluetooth low energyâs enormous power efficiency. BlueSlim2 utilizes USB, the dominant standard interface for most PC platforms, so it can be easily connected to a vast range of PC devices. The applications can be Laptops, Tablet, All-in-one, digital TV, set-top box, and versatility of consumer products. 1.1 APPEARANCE Top view Bottom view 1.2 BLOCK DIAGRAM 2. FEATURES 6 pin connector. HCI mode operation with USB2.0 full speed (12Mbps). Fully qualified BluetoothÂŽ spec v2.1/2.1+EDR/3.0/3.0+HS/4.0, and LE. Dual-mode Bluetooth/Bluetooth Low Energy operation. Support for Bluetooth basic rate / EDR and low energy connection. COPYRIGHT Š 2014 Wistron Corporation, ALL RIGHTS RESERVED. Powered by +3.3V. Onboard Printed antenna. Class1, Class2, Class3 supported. Measured Max. TX output power up to 6dBm, max. distance range 30 meters (Class1). Halogen free / ROHS compliance. 3. SPECIFICATIONS 3.1 GENERAL SPECIFICATIONS Model Name BlueSlim2 Main Chipset BlueCoreÂŽ CSR8510A10 EEPROM 32Kbit Standard Bluetooth spec v2.1, v2.1+EDR, v3.0, v3.0+HS, v4.0, LE(Low Energy) Bus Interface USB2.0 full speed Connector 6 pins, pitch=0.6 ACES (5037600601001) 1*6 P=0.6mm R/A SMD HF , or equivalent. Antenna Printed antenna Shielding case Yes Dimensions (L*W*H) 6.5mm*30mm*2mm Surface mount single side Surface Mount Operating voltage 3.3 V Âą10% COPYRIGHT Š 2014 Wistron Corporation, ALL RIGHTS RESERVED. Integrated linear regulators: USB: USB bus supply to 3.3V High-voltage: 2.3V to 4.8V input to 1.85V Low-voltage: VDD_DIG, VDD_RADIO and VDD_AUX regulators Power-on-reset cell detects low supply voltage Arbitrary sequencing of power supplies is permitted 3.2 ELECTRICAL CHARACTERISTICS Frequency Range 2.402GHz to 2.480GHz, ISM band Radio Technology FHSS (Frequency Hopping Speed Spectrum) Basic Data Rate 1Mbps (GFSK) Enhanced Data Rate 2Mbps (DQPSK); 3Mbps (8-DPSK) Channel Number 79 Channels, 1MHz bandwidth 3.3 POWER MEASUREMENT Supply voltage +3,3V (Min. 3.0V; Max. 3.6V) Continuous TX supply current 57mA Continuous RX supply current 46mA Bluetooth Power ON (RF off) 14mA COPYRIGHT Š 2014 Wistron Corporation, ALL RIGHTS RESERVED. 3.4 MODULE PIN ASSIGNMENT PIN VCC 3.3V GND USB D+ USB D- Reserved; unused. Reserved; unused. 3.5 Module Dimension BlueSlim2 Length Width Height PCB Dimension 6.5mm (Âą1.5%) 30mm (Âą1.5%) 0.8mm (Âą1.5%) Module 6.5mm (Âą1.5%) 30mm (Âą1.5%) Max. height of Dimension Shielding Case TOP 1.15mm BOTTOM Total height = 2mm (Max. 2mm) 3.6 ENVIRONMENTAL Operating Operating Temperature: 0°C to +70 °C Relative Humidity: 5-90% (non-condensing) Storage Temperature: -20°C to +85°C (non-operating) Relative Humidity: 5-95% (non-condensing) COPYRIGHT Š 2014 Wistron Corporation, ALL RIGHTS RESERVED. 3.7 SOFTWARE OS supported: Linux / Android/ Windows BT Stack: Please check the 3rd-party BT software utility or what stack which your OS has supported. 3.8 FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the userâs authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference and 2) this device must accept any interference received, including interference that may cause undesired operation of the device. FCC RF Radiation Exposure Statement: COPYRIGHT Š 2014 Wistron Corporation, ALL RIGHTS RESERVED. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: âContains FCC ID: PU5BT3â Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the userâs manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warming as shown in this manual. The end product may also subject to fulfill FCC part 15B (un-intentional emission) requirement while module is being installed. 3.9 IC Statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: ďźThis device may not cause interference ďźThis device must accept any interference, including interference that may cause undesired operation of the device Le prĂŠsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.L'exploitation est autorisĂŠe aux deux conditions suivantes: ďźl'appareil ne doit pas produire de brouillage, et ďźl'utilisateur de l'appareil doit accepter tout brouillage radioĂŠlectrique subi, mĂŞme si le brouillage est susceptible d'en compromettre le fonctionnement. Caution: Exposure to Radio Frequency Radiation. To comply with RSS 102 RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. Pour se conformer aux exigences de conformitĂŠ CNR 102 RF exposition, une distance de sĂŠparation d'au moins 20 cm doit ĂŞtre maintenue entre l'antenne de cet appareil et toutes les personnes. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: "Contains IC: 4182A-Z01C" 3.10 ć šć NCC ä˝ĺçéťćł˘čźťĺ°ć§éťćŠçŽĄç螌ćłčŚĺŽ 珏ĺäşć˘ çśĺĺźčŞčĺć źäšä˝ĺçĺ°é ťéťćŠďźéçśč¨ąĺŻďźĺ Źĺ¸ăĺčć使ç¨č ĺä¸ĺžć čŞčŽć´ é ťçăĺ 大ĺçćčŽć´ĺč¨č¨äšçšć§ĺĺč˝ă 珏ĺĺć˘ ä˝ĺçĺ°é ťéťćŠäšä˝żç¨ä¸ĺžĺ˝ąéżéŁčŞĺŽĺ ¨ĺ嚲ćžĺćłé俥ďźçśçźçžć嚲ćžçžčąĄćďźć çŤĺłĺç¨ďźä¸ŚćšĺčłçĄĺš˛ćžććšĺžçšźçşä˝żç¨ăĺé ĺćłé俥ďźćäžéťäżĄćłčŚĺŽä˝ćĽäšçĄçˇéťé 俥ăä˝ĺçĺ°é ťéťćŠé ĺżĺĺćłé俥ć塼ćĽăç§ĺ¸ĺéŤçç¨éťćł˘čźťĺ°ć§éťćŠč¨ĺäšĺš˛ćžă ć¤ć¨ĄçľćźĺĺžčŞčĺžĺ°äžčŚĺŽćźć¨ĄçľćŹéŤć¨ç¤şĺŻŠéŠĺć źć¨çą¤ďźä¸ŚčŚćąĺšłĺ°ĺť ĺćźĺšłĺ°ä¸ć¨ç¤şă ăćŹç˘ĺĺ §ĺŤĺ°é ťć¨ĄçľďźID 硨č XXXXXăĺ樣 COPYRIGHT Š 2014 Wistron Corporation, ALL RIGHTS RESERVED. 4. PACKAGE TRAY SPECIFICATION Dimension: 331*137*97mm CARTON SPECIFICATION Dimension: 350*143*77mm QâTY/TRAY 800pcs/16+1 tray , TOTAL: 800pcs /Carton COPYRIGHT Š 2014 Wistron Corporation, ALL RIGHTS RESERVED.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Author : Karen Create Date : 2017:03:22 15:19:39+08:00 Modify Date : 2017:03:24 14:31:25+08:00 Subject : Has XFA : No XMP Toolkit : Adobe XMP Core 5.4-c006 80.159825, 2016/09/16-03:31:08 Creator Tool : Nitro Pro 10 (10. 5. 8. 44) Metadata Date : 2017:03:24 14:31:25+08:00 Format : application/pdf Creator : Karen Title : BlueSlim2_CSR8510A10__spec_v0.93_Wistron Corporation_.pdf Description : Keywords : Producer : Acrobat Distiller 9.0.0 (Windows) Document ID : uuid:f1504e70-5da7-47d1-94a8-4ace554e34db Instance ID : uuid:e873a856-f140-492e-8f48-d0d1bb34744f Page Count : 10EXIF Metadata provided by EXIF.tools