XAC Automation RP10 PINPAD User Manual

XAC Automation Corporation PINPAD

User Manual

d INSTRTO TALLATIOOS PAYMERP-1ON GUIDEENT DEVICE10 E E
1. PACKAGE CONTENT 2. DEVICE OVERVIEW RP‐10KeyButtons&InterfacePorts(Figure1): Figure1FRONTAREA1 2.4” Display 2 Rubber Keypad 3 Magnetic Strip Reader (MSR) slot 4 Smart Card Reader (SCR) slot REARAREA5 USB cable (type A) 6 Battery Compartment FRONTREAR RP-10  Privacy Shield (Optional)
■ RP-10 power spec: Input:5VDC,0.5A OperatingTemperature:0oCto40oC3. POWER ON/OFF THE DEVICE Topoweronthedevice,pleaseplugtheUSBcableintotheUSBportofyourhostterminalorPOS.Note:WhenthereisnoactiononRP‐10after60seconds,thedevicewillenterpowersavingmode.Pleaseshortpressanybuttononkeypadtowakeupthedevice.  4. USING THE MAGNETIC CARD READER Swipethecardthroughtheslotwithmagneticstripesidefacingthesamedirectionasthedisplay.(Figure3) Figure3 5. USING THE IC CARD READER InsertanICcardintotheslot(Figure4)withthechipsidefacingthesamedirectionasthetouchpanel(Figure5). Figure4Figure5
6. USING THE KEY PAD Afterinsertingthechipcard,Pressthenumerickeyasbelowkeypad(Figure6)toenterthedesirablenumbers.PressCancel(X)keytoterminateanycurrentfunctionandpresstheEnter(O)keytoconfirmavalueoranoption. Figure6 7. USING THE CONTACTLESS CARD READER Tapthecontactlesscardontopofthecontactlesslogo(Figure7). Figure7 9. INSERT SIM & SAM CARD Afterremovingthebatterycover,theusercanfindSAM*2slotsatthebottomsideofdevice.Pleaseinsertthecardcorrectlyastheiconshownonthecover:
Figure10 FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation. XAC Automation Corporation 886-3-577-2738

Navigation menu