Danalock V3 Product Manual Z Wave V 0.9.1

2018-11-29

: Z-Wave Danalock V3 Product Manual Z Wave V 0.9.1 Danalock_V3_Product_manual_Z_Wave_V_0.9.1 733 docs

Open the PDF directly: View PDF PDF.
Page Count: 6

Scroll down to view the document on your mobile browser.
1 | P a g e Danalock V3 Product manual The Danalock V3 Z-Wave is a secure electronic door lock that supports the Z-Wave Plus standard, which is compatible with earlier versions of Z-Wave. The Danalock is battery supplied and therefore it is a FLIRS Frequently Listening Routing Slave which conserves battery The Danalock V3 is a security enabled Z-Wave Plus Product. A security enabled Z-Wave controller must be use. The Danalock V3 supports the standard security S0 and the new security standard S2. This manual covers all versions of Danalock V3 Z-Wave. This manual is accompanied by the mounting manually for your specific lock. Z-Wave interoperability The Danalock can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. Z-Wave add/inclusion and remove/exclusion • To add or include the Danalock into a Z-Wave network 1. Set the controller in inclusion mode 2. Push the switch once. 3. Wait 5 seconds. • To remove or exclude the Danalock into a Z-Wave network 1. Set the controller in exclusion mode 2. Push the switch once. 3. Wait 5 seconds. Factory Reset The Danalock can be set to factory settings by pushing the switch ten times. Please use this procedure only when the primary controller is missing or otherwise inoperable. Batteries The Danalock uses 4 CR123A batteries. Only use four new batteries from the same manufacturer. Do not mix new and old batteries. The Package contains • Danalock V3 • Batteries (may not be included) • Manual • Adapters (may vary from country to country) If the Danalock is firstly included on a Z-Wave network, the Bluetooth Smart is disabled because of security and to conserve power. To enable Bluetooth Smart enable Configuration byte no. 5.
2 | P a g e Supported Command Classes Command Class Version Not added Non-Secure added Securely added Non-secure CC Secure CC Z-Wave Plus Info 2 Support Support Support Transport Service 2 Support Support Support Security 0 1 Support Support Support Security 2 1 Support Support Support Association 2 Support Association Grp Info 1 Support Battery 1 Support Configuration 1 Support Device Reset Locally 1 Support Door lock 2 Support Firmware update MD 4 Support Manufacturer Specific 2 Support Notification 8 Support Power level 1 Support Superversion 1 Support Version 2 Support Node Info Generic Device Class 0x40 GENERIC_TYPE_ENTRY_CONTROL Specific Device Class 0x03 SPECIFIC_TYPE_SECURE_KEYPAD_DOOR_LOCK Association CC V2 (secure) Associations Groups Group 1 is Lifeline. All unsolicited reports are sent to the node in Lifeline. The Danalock can send the following commands through Lifeline: ID Name Node Count Description 1 Lifeline 1 Supports the following command classes: • Device Reset Locally: triggered upon reset. • Battery/notification: triggered upon low battery. • Door Lock operation report: triggered upon a change in door lock • Notification: triggered upon a change in door lock Battery CC V1 (secure & unsecure) The Battery Get request can be used to get the status of the battery. To get a useful battery level the motor of the lock should be operated at least once for the lock to sample a meaningful battery level. When battery level is low a battery warning is send to the controller.

Navigation menu