ZTE ZTEV831W WCDMA/GSM(GPRS)Dual-Mode Digital Mobile Phone User Manual 1920 Dtac Manual User Cre 4 5Ver
ZTE Corporation WCDMA/GSM(GPRS)Dual-Mode Digital Mobile Phone 1920 Dtac Manual User Cre 4 5Ver
ZTE >
User manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 2542044 |
| Application ID | 91wB3jrXFPsMa61OAbw8HQ== |
| Document Description | User manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 424.69kB (5308608 bits) |
| Date Submitted | 2015-02-27 00:00:00 |
| Date Available | 2015-03-02 00:00:00 |
| Creation Date | 2017-11-02 03:05:57 |
| Producing Software | GPL Ghostscript 9.18 |
| Document Lastmod | 2017-11-02 03:05:57 |
| Document Title | 1920 Dtac Manual User_Cre-4.5Ver |
| Document Creator | Adobe Illustrator CS5 |
คูม่ ือการเริ่ มต้นการใช้ โทรศัพท์มือถือ Dtac Trinet Phone Joey Fit Selfie 4.5 -1- ก -2- -3- ะ ซมิการด์ GSM 3G/WCDMA และ ะลง การเปิ ดปิ ดโทรศัพท์ ่ ่จะเปิ ดเครื่ อง ตรวจสอบแบตเตอรี่ ชาร์จกอนที •กดปุ่ มเปิ ดปิ ดเครื่ องเพื่อเปิ ดโทรศัพท์ หากต้องการปิ ดเครื่ องกดเปิ ดปิ ดเครื่ องค้างไว้ เพื่อเปิ ดเมนูตวั เลือก กด ปิ ดเครื่ อง>ตกลง -9- อุปกรณ์ การแพทย์ โรงพยาบาน บน Dtac Trinet Phone Joey Fit Selfie 4.5 Quick Start Guide Getting to Know Your Phone 3 Power Key Press and hold to power on, select phone modes, turn on/off airplane mode, reboot your phone, or power off. Press to turn off or on the screen display. Home Key Touch to return to the home screen from any application or screen. Menu Key Touch to get the options for the current screen. Touch and hold to see recently used applications. Back Key Touch to go to the previous screen. Volume Key Press or hold to turn the volume up or down. Starting Up Switch off your phone before installing or replacing the battery or the SIM card. The microSDHC™ card is optional and can be installed and removed while the phone is turned on. Unmount the microSDHC card before removing it. 1. Place your finger in the slot at the bottom of the back cover to lift and remove the cover. 2. Hold the SIM card with its cut corner oriented as shown and slip it into the card holder. GSM 3G/WCDMA 3. Hold your microSDHC card with the metal contacts facing down and slide it into the microSDHC card slot. 4. Align the connectors on the phone and the battery and slide the battery into the compartment. Then gently press the battery down until it is secured. 5. Align the back cover with the back of the phone and press the cover back into place. Make sure all the tabs are secure and there are no gaps around the cover. Charging the Battery 1. Connect the adapter to the charging jack. Ensure that the adapter is inserted with the correct orientation. Do not force the connector into the charging jack. 2. Connect the charger to a standard AC power outlet. 3. Disconnect the charger when the battery is fully charged. Powering On/Off Your Phone Make sure the battery is charged before powering on. Press and hold the Power Key to turn on your phone. To turn it off, press and hold the Power Key to open the options menu. Touch Power off > OK. Product Safety Information Do not use hand-held while driving Do not use while re-fuelling For body-worn operation maintain a separation of 15 mm This device may produce a bright or flashing light Small parts may cause a choking hazard Do not dispose of it in a fire This device may produce a loud sound 10 To prevent possible hearing damage, do not listen at high volume levels for long periods. Avoid contact with magnetic media Avoid Extreme Temperatures Keep away from pacemakers and other personal medical devices Avoid any contact with liquid, keep it dry Switch off when instructed in hospitals and medical facilities Do not attempt to disassemble Switch off when instructed in aircrafts and airports 11 Only use approved accessories Switch off in explosive environments Do not rely on this device for emergency communications 12 FCC Regulations: This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. FCC Note: Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment. RF Exposure Information (SAR) This phone is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States. During SAR testing, this device was set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage against the head with no separation, and near the body with the separation of 10 mm. Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. The exposure standard for wireless devices employing a unit of measurement is known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. This device is complied with SAR for general population /uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and had been tested in accordance with the measurement methods and procedures specified in IEEE1528. This device has been tested and meets the FCC RF exposure guidelines when tested with the device directly contacted to the body. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: SRQ-ZTEV831W. For this device, the highest reported SAR value for usage against the head is 0.62 W/kg, for usage near the body is 0.99 W/kg. While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirements. SAR compliance for body-worn operation is based on a separation distance of 10 mm between the unit and the human body. Carry this device at least 10 mm away from your body to ensure RF exposure level compliant or lower to the reported level. To support body-worn operation, choose the belt clips or holsters, which do not contain metallic components, to maintain a separation of 10 mm between this device and your body. RF exposure compliance with any body-worn accessory, which contains metal, was not tested and certified, and use such body-worn accessory should be avoided.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Encryption : Standard V4.4 (128-bit) User Access : Print, Extract, Print high-res Create Date : 2014:08:06 11:06:22+09:00 Creator : Adobe Illustrator CS5 Modify Date : 2015:02:27 12:01:49+08:00 Has XFA : No XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00 Format : application/pdf Title : 1920 Dtac Manual User_Cre-4.5Ver Metadata Date : 2015:02:27 12:01:49+08:00 Creator Tool : Adobe Illustrator CS5 Thumbnail Width : 128 Thumbnail Height : 256 Thumbnail Format : JPEG Thumbnail Image : (Binary data 7443 bytes, use -b option to extract) Instance ID : uuid:c7bd5432-cd5e-4f35-837f-deffb60ffb8f Document ID : xmp.did:A9CD4313041DE411BB4AC3DDFEAFF8B6 Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : xmp.iid:A8CD4313041DE411BB4AC3DDFEAFF8B6 Derived From Document ID : xmp.did:A8CD4313041DE411BB4AC3DDFEAFF8B6 Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved, saved, saved, saved, saved History Instance ID : xmp.iid:0580117407206811808398B6FF718213, xmp.iid:0680117407206811808398B6FF718213, xmp.iid:01801174072068118083D62455CE6A59, xmp.iid:F77F1174072068118083F659D2B375AC, xmp.iid:A8CD4313041DE411BB4AC3DDFEAFF8B6, xmp.iid:A9CD4313041DE411BB4AC3DDFEAFF8B6 History When : 2014:07:25 14:36:03+07:00, 2014:07:25 15:31:05+07:00, 2014:07:25 17:55:35+07:00, 2014:07:25 18:52:29+07:00, 2014:08:06 11:02:53+08:00, 2014:08:06 11:06:19+08:00 History Software Agent : Adobe Illustrator CS5.1, Adobe Illustrator CS5.1, Adobe Illustrator CS5.1, Adobe Illustrator CS5.1, Adobe Illustrator CS5, Adobe Illustrator CS5 History Changed : /, /, /, /, /, / Startup Profile : Print Has Visible Overprint : False Has Visible Transparency : True N Pages : 1 Max Page Size W : 170.078125 Max Page Size H : 340.158203 Max Page Size Unit : Points Plate Names : Black Swatch Groups Group Name : 默认色板组 Swatch Groups Group Type : 0 Producer : Adobe PDF library 9.90 Page Count : 27EXIF Metadata provided by EXIF.tools