dormakaba Canada A38880 BLE SMART communication board User Manual Service Plan 760 lock series

Kaba Ilco Inc. BLE SMART communication board Service Plan 760 lock series

UserManual.wiki >

dormakaba Canada >

A38880 User Manual

User Manual

BLE Module Installation Guide Document No. Revision: 3 Prepared by: Charles Grimm Date: 10/22/2015 BLE_Upgrade_Modified_Rev3 1 of 5 BLE Module Installation Guide

BLE Module Installation Guide Document No. Revision: 3 Prepared by: Charles Grimm Date: 10/22/2015 BLE_Upgrade_Modified_Rev3 2 of 5 REVISION HISTORY Rev. Date Description Made by Checked Approved 1 10/22/2015 Release of document CG TABLE OF CONTENTS 1. INSTALL DOUBLE DECKER END CAP .................................................................................................................................... 3 2. LABEL UPGRADES AND ADDITIONS ...................................................................................................................................... 5

BLE Module Installation Guide Document No. Revision: 3 Prepared by: Charles Grimm Date: 10/22/2015 BLE_Upgrade_Modified_Rev3 3 of 5 1. Install Double Decker End Cap Install the communication boards as shown. RF board is in the upper position if present. BLE board is in the lower position. Ensure the wires run through the notch in the cap so they do not become pinched when the cap is installed on the chassis. Install the end cap onto the chassis by pressing it over the screw post as shown.

BLE Module Installation Guide Document No. Revision: 3 Prepared by: Charles Grimm Date: 10/22/2015 BLE_Upgrade_Modified_Rev3 4 of 5 Connect the BLE module wire harness to the MT4 PCB as shown. Ensure all wires are connected and routed properly and will not be pinched when the cover is reinstalled. Zigbee Connection (If applicable) BLE Connection

BLE Module Installation Guide Document No. Revision: 3 Prepared by: Charles Grimm Date: 10/22/2015 BLE_Upgrade_Modified_Rev3 5 of 5 2. Label Upgrades and Additions Reinstall the escutcheon and tighten the screws with a tamper resistant T20 bit. Ensure the “DEAD BOLT CAM POSITION” label is replaced with the latest MT4 version. Part Number: A37780 The FCC Enclosure label for the BLE board must be added to the lock and will be placed as shown for field upgrades. Note: Part displayed is the inside cover Regulatory Compliance: This device complies with Part 15 of the FCC Rules,. Operation is subject to the following two conditions: (1) this device may not cause harmful inter-ference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications of this product, not approved by manufacturer will void the user’s authority to operate the equipment. “This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.”