dormakaba Canada A38880 BLE SMART communication board User Manual Service Plan 760 lock series
Kaba Ilco Inc. BLE SMART communication board Service Plan 760 lock series
User Manual
BLE Module Installation Guide
Document No.
Revision:
3
Prepared by: Charles Grimm
Date: 10/22/2015
BLE_Upgrade_Modified_Rev3
1 of 5
BLE Module Installation Guide
BLE Module Installation Guide
Document No.
Revision:
3
Prepared by: Charles Grimm
Date: 10/22/2015
BLE_Upgrade_Modified_Rev3
2 of 5
REVISION HISTORY
Rev.
Date
Description
Made by
Checked
Approved
1
10/22/2015
Release of document
CG
TABLE OF CONTENTS
1. INSTALL DOUBLE DECKER END CAP .................................................................................................................................... 3
2. LABEL UPGRADES AND ADDITIONS ...................................................................................................................................... 5
BLE Module Installation Guide
Document No.
Revision:
3
Prepared by: Charles Grimm
Date: 10/22/2015
BLE_Upgrade_Modified_Rev3
3 of 5
1. Install Double Decker End Cap
Install the communication boards as shown.
RF board is in the upper position if present.
BLE board is in the lower position.
Ensure the wires run through the notch in
the cap so they do not become pinched
when the cap is installed on the chassis.
Install the end cap onto the chassis by pressing it
over the screw post as shown.
BLE Module Installation Guide
Document No.
Revision:
3
Prepared by: Charles Grimm
Date: 10/22/2015
BLE_Upgrade_Modified_Rev3
4 of 5
Connect the BLE module
wire harness to the MT4
PCB as shown.
Ensure all wires are
connected and routed
properly and will not be
pinched when the cover is
reinstalled.
Zigbee Connection
(If applicable)
BLE Connection
BLE Module Installation Guide
Document No.
Revision:
3
Prepared by: Charles Grimm
Date: 10/22/2015
BLE_Upgrade_Modified_Rev3
5 of 5
2. Label Upgrades and Additions
Reinstall the escutcheon and tighten the screws
with a tamper resistant T20 bit.
Ensure the “DEAD BOLT CAM POSITION”
label is replaced with the latest MT4 version.
Part Number: A37780
The FCC Enclosure label for the BLE board
must be added to the lock and will be placed as
shown for field upgrades.
Note: Part displayed is the inside cover
Regulatory Compliance:
This device complies with Part 15 of the FCC Rules,. Operation
is subject to the following two conditions: (1) this device may not
cause harmful inter-ference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Any changes or modifications of this product, not approved by
manufacturer will void the user’s authority to operate the
equipment.
“This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.”