Chantry Networks BP200E Access Point with WLAN and UNII User Manual quickstart

users manual addendum

Chantry

Beaconworks

Addendum to Quick start Guide Release 1.1

NOTE:

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Caution:

There should be at least 9 inches (20 cm) separation between the

BeaconPoint and users.

Any changes or modifications not expressly approved by Chnatry Networks

could void the user’s authority to operate the equipment.

The BeaconPoints shall be powered by UL approved limited power source

adapter or UL approved limited power source power over ethernet (P.O.E.).

The BP200 product will automatically discontinue transmission in case of

either absence of information(no frames transmitted trough Ethernet) to

transmit or operational failure.