Garmin 02670 Wireless Dog Trainer User Manual
Garmin International Inc Wireless Dog Trainer
Garmin >
Manual
AF Sport PRO™ Quick Start Manual April 2015 Printed in Taiwan 190-01893-01_0A Getting Started Device Overviews Sport PRO Handheld Device WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Setting Up the Sport PRO System AF Before you can use the Sport PRO system, you must set up the devices. 1 Attach the dog collar device to the collar strap (page 3). 2 Charge the handheld device (page 3). 3 Charge the dog collar device (page 4). 4 Turn on the devices (page 5). 5 If necessary, pair the dog collar device with the handheld device (page 5). À Á  Dog collar device toggle switch Intensity level and training mode dial Continuous stimulation key BarkLimiter™ on key (AUX mode) à Momentary stimulation key BarkLimiter off key (AUX mode) Ä Vibration key Light on key (AUX mode) Å Tone key Light off key (AUX mode) Getting Started Sport PRO Dog Device 3 Insert the end of the collar strap through the slot à on the opposite side of the device. 4 Pull the strap until it is tight across the front of the device. Power key Status LED Lights Contact points Charging clip contacts Attaching the Dog Collar Device to the Collar Strap 1 With the buckle À facing outward, insert the end of the collar strap through the slot Á on the collar device. NOTICE To prevent corrosion, thoroughly dry the USB port, the weather cap, and the surrounding area before charging or connecting to a computer. AF À Á Â Ã Ä Charging the Handheld Device You should fully charge the battery before you use the device for the first time or whenever the battery is low. It is normal for the battery to discharge in approximately 7 to 10 weeks when the device is not in use. Charging a fully depleted battery takes about 2 hours. NOTE: The device will not charge when it is outside the temperature range of 32° to 104°F (0° to 40°C). 1 Lift the weather cap À. 2 Pull most of the collar strap through the two slots  on the dog device. Getting Started 4 After the status LED turns solid green, unplug the power cable from the device. Charging the Dog Collar Device NOTICE To prevent corrosion, thoroughly dry the contacts on the collar and the surrounding area before connecting the charging clip. AF You should fully charge the battery before you use the device for the first time or whenever the battery is low. It is normal for the battery to discharge in approximately 7 to 10 weeks when the device is not in use. Charging a fully depleted battery takes about 2 hours. NOTE: The device will not charge when outside the temperature range of 32° to 104°F (0° to 40°C). 1 Snap the charging clip À onto the device Á. You should fully charge the battery before you use the device for the first time or whenever the battery is low. It is normal for the battery to discharge in approximately 7 to 10 weeks when the device is not in use. Charging a fully depleted battery takes about 2 hours. 2 Plug the small end of the power cable into the mini-USB port Á on the device. 3 Plug the other end of the power cable into an appropriate power source. The status LED is solid red when the device is charging. Getting Started AF yellow to enter pairing mode (page 5). Turning Off the Device 1 On the dog collar device, hold the power key until the red LED appears. 2 Release the power key. The dog collar device beeps to confirm powering off. NOTE: If the device is powered off in BarkLimiter mode, the LED flashes the number of corrected barks before powering off . 2 Plug the power cable into a power source. The status LED is solid red when the collar is charging. 3 After the status LED turns solid green, remove the charging clip from the collar. • On the dog collar device, hold the power key until the status LED turns green and the collar beeps to turn it on in training mode. On the dog collar device, hold the power key until the status LED turns blue to turn on the BarkLimiter feature. On the dog collar device, hold the power key until the status LED turns • Turning On the Dog Collar Device • Getting Started Dog Collar Device You can use up to 3 dog collar devices with a single handheld device. Each dog collar device must be paired with the handheld device before it can be used. During the pairing process, each dog collar device is associated with a different color on the handheld device. Pairing a Dog Collar Device with the Handheld Device NOTE: If your handheld device and dog collar device were included in the same package, the devices are paired from the factory. The training keys control the dog collar device associated with the selected color. Dog Training You should research and investigate the training methods best suited for you, your dog, and your needs. When used properly, the Sport PRO training system is an effective training tool to aid your dog in reaching its full potential. The use of the training system should be part of an overall training program. AF toggle switch and select a key to choose the color associated with the dog collar device. 2 On the handheld device, set the intensity level to a numbered position. 3 On the dog collar device, hold the power key for about 5 seconds until the status LED changes to yellow. 4 On the handheld device, select a training key. The dog collar device beeps when the devices have paired successfully. If the device does not beep, pairing has not been successful. TIP: If the devices did not pair successfully, you should verify the batteries in both devices are fully charged and the intensity level is set to a numbered position. Selecting a Dog Collar Device Before you can select and control a dog collar device, you must pair the dog collar device with the handheld device (page 5). Move the dog collar device toggle switch to select the color associated with a dog collar device. 1 On the handheld device, move the Fitting the Collar on Your Dog CAUTION To prevent irritation from the contact points, remove the collar for at least eight hours out of every 24-hour period. This device is not intended for human use. Do not attempt to use on any person. Do not spray the device or collar with harsh chemicals including but not limited to flea or tick spray. Always ensure that any flea or tick spray that is applied to the dog is completely dry before placing the collar on the dog. Small amounts of harsh chemicals can damage the plastic components and collar laminate. Dog Training T behavior to verify that the collar is not too tight. AF In order to properly correct the dog, the collar and device must fit the dog properly. If the collar is too loose or positioned incorrectly, corrections may be inconsistent. This can delay or prevent successful training. 1 Position the device at the front of the dog's neck, with the status LED facing toward the dog's chin and the contact points against the throat. TIP: For bark correction, the device contact points should be positioned near the dog's vocal cords. This location varies based on the breed of dog. If the device does not seem to detect the dog's barks, you should move the device closer to or farther from the dog's body to find the ideal location. 2 Tighten the strap so that it is very snug around the dog's neck, and fasten the buckle. NOTE: The collar should fit tightly and should not be able to rotate or slide on the dog's neck. The dog must be able to swallow food and water normally. You should observe your dog's Dog Training 3 Wiggle the device to work the contact points through the dog's coat. NOTE: The contact points must have contact with the dog's skin to be effective. 4 If the strap is too long, cut off the excess, leaving at least 3 in. (8 cm) to spare. TIP: You can mark the hole used to fasten the buckle for future reference. T Continuous stimulation: Applies stimulation to the dog the entire time you press the training key, for a maximum of 8 seconds. Your stimulations should typically be much shorter than 8 seconds. Tone: Activates an audible tone instead of stimulation. A tone can be used as either a positive or negative training cue, depending on your training program. Vibration: Applies vibration instead of stimulation to the dog the entire time you press the training key, for a maximum of 8 seconds. The effectiveness of vibration may vary based on the dog's temperament and experience. AF Selecting and Installing the Contact Points For best results, select the correct contact points based on your dog's coat. 1 Select the correct contact point length for your dog's coat type: • For dogs with thicker coats, use the longer contact points. • For dogs with shorter coats, use the shorter contact points. 2 If necessary, use the included wrench to remove the contact points. 3 Twist the contact points into the collar. 4 Tighten with the included wrench, but do not overtighten. When you put the collar on the dog, make sure the contact points are tight against the neck. Training Methods NOTE: Training features are not available in all areas for tracking collars. Momentary stimulation: Applies a brief stimulation when you press the training key, regardless of how long the key is depressed. Device Information Handheld Device Specifications Battery type Rechargeable lithium-ion Battery life 60 hr. typical use Operating From -20° to 60°C (from temperature range -4° to 140°F) Charging From 0° to 40°C (from temperature range 32° to 104°F) Device Information Storage From -20° to 35°C (from temperature range -4° to 95°F) (up to 3 months) Water rating IEC 60529 IPX7* Registering Your Device Help us better support you by completing our online registration today. • Go to http://my.garmin.com. • Keep the original sales receipt, or a photocopy, in a safe place. Getting More Information You can find more information about this product on the Garmin website. • Go to www.garmin.com/outdoor. • Go to http://buy.garmin.com, or contact your Garmin dealer for information about optional accessories and replacement parts. AF *The device withstands incidental exposure to water of up to 1 m for up to 30 min. For more information, go to www.garmin.com/waterrating. information, go to www.garmin.com /waterrating. Storage From -20° to 50°C (from temperature range -4° to 122°F) (up to 1 month) Dog Collar Device Specifications Battery type Rechargeable, replaceable lithium-ion Battery life 60 hr. typical use Operating From -20° to 60°C (from temperature range -4° to 140°F) ® Charging From 0° to 40°C (from temperature range 32° to 104°F) Storage From -20° to 50°C (from temperature range -4° to 122°F) (up to 1 month) Storage From -20° to 35°C (from temperature range -4° to 95°F) (up to 3 months) Water rating 1 ATM* *The device withstands pressure equivalent to a depth of 10 m. For more Device Information T AF T AF Garmin and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. Sport PRO™ is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin. ® + 32 2 672 52 54 0800 770 4960 1-866-429-9296 +385 1 5508 272 +385 1 5508 271 +420 221 985466 +420 221 985465 + 45 4810 5050 + 358 9 6937 9758 CAN ICES-3(B)/NMB-3(B) AF +43 (0) 820 220230 www.garmin.com/support + 331 55 69 33 99 + 39 02 36 699699 (+52) 001-855-792-7671 0800 0233937 00800 4412 454 +44 2380 662 915 +47 815 69 555 (+35) 1214 447 460 +386 4 27 92 500 0861 GARMIN (427 646) +27 (0)11 251 9999 +34 93 275 44 97 + 46 7744 52020 +49 (0)180 6 427646 20 ct./Anruf. a. d. deutschen Festnetz, Mobilfunk max. 60 ct./Anruf 0808 238 0000 +44 (0) 870 8501242 +886 2 2642-9199 ext 2 913-397-8200 1-800-800-1020 © 2015 Garmin Ltd. or its subsidiaries
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.7 Linearized : Yes Create Date : 2015:04:29 16:54:22-06:00 Creator : AH XSL Formatter V6.2 MR5 for Windows (x64) : 6.2.7.18952 (2014/11/12 16:18JST) Modify Date : 2015:06:17 14:41:55-07:00 Subject : Trapped : False Has XFA : No XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 GTS PDFX Version : PF_PDFX_3_2003 Document ID : uuid:864e96de-1641-c58c-d646-4fe8b8e9ed03 Version ID : 1 Rendition Class : default Instance ID : uuid:d32d5a35-bccf-46ba-9c40-1ddd67c4193e Producer : Antenna House PDF Output Library 6.2.625 (Windows (x64)) Creator Tool : AH XSL Formatter V6.2 MR5 for Windows (x64) : 6.2.7.18952 (2014/11/12 16:18JST) Metadata Date : 2015:06:17 14:41:55-07:00 Format : application/pdf Description : Title : Untitled Page Layout : SinglePage Page Count : 12EXIF Metadata provided by EXIF.tools