HWM Water 485 EchoChirp AMR Transmitter User Manual User guide 3

User guide 3

485-022-V2

485-024-V2

FCC ID: RUZ-485

Temperature

Part number : MAN-485-0030-B

If further support or assistance is required, please contact FCS

Technical Support on 1-800-531-5465

or e-mail sales@uidconservaon.com

WARNING: - LITHIUM BATTERIES

If baeries are exposed - do not short circuit, re-charge, puncture, incinerate, crush, immerse, force

discharge or expose to temperatures above the declared operang temperature range of the product.

Risk of re or explosion. These baeries are sealed units which are not hazardous when used according

to the recommendaons of the manufacturer.

2. OPERATION

The reed switch is located on the front right of the unit. The unit will normally be

transming out of the box. If a restart is required or the unit doesn’t appear to transmit,

use the reed switch to iniate transmission. Hold a magnet to close the reed switch and

cause the rmware reset. A click from the reed switch may be heard followed by a

transmission burst.

Reed switch operaon can be veried using an RF scanner tuned to the transmission

frequency, when transming a burst or blip can be heard.

1. INSTALLATION

Opmum operang temperature should be below +50°C. We cannot guarantee the maxi-

mum life; therefore it is recommended to keep within the opmum operaon tempera-

ture range for maximum baery performance.

If monitoring hot water systems it is not advisable to mount the transmier directly on the

pipe without intervening insulaon.

For maximum transmission range the antenna of the transmier should point upward

(vercal polarizaon) and should be kept clear of obstrucons, parcularly metallic

surfaces. Mounng brackets are available, to t the cavity at the rear of the transmier.

Operang in extreme environmental condions will degrade the life-me of the baery.