Hospira 20677 PlumA + with MedNet Wireless Enabled Infuser User Manual sec07

Download:
Mirror Download [FCC.gov]
Document ID	545437
Application ID	2bzNWhkWyVLoiqr0RjLmpQ==
Document Description	Replacement Installation Guide
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	11.65kB (145651 bits)
Date Submitted	2005-05-25 00:00:00
Date Available	2005-05-25 00:00:00
Creation Date	2005-05-19 16:48:40
Producing Software	Acrobat Distiller 6.0.1 (Windows)
Document Lastmod	2005-05-19 17:05:41
Document Title	sec07.fm
Document Creator	PScript5.dll Version 5.2
Document Author:	cossabd

7.2
REPLACEMENT PROCEDURES
7.2.6
CE MODULE REPLACEMENT
The recommended tool for this procedure is a No. 2 Phillips screwdriver.
The replacement parts for this procedure are:
CE Module
Screw, 4-40 x 1/4, Pan Head, Square Cone
CAUTION: Use proper ESD grounding techniques when handling components.
Wear an antistatic wrist strap and use an ESD-protected workstation. Store the PWA
in an antistatic bag before placing it on any surface.
CAUTION: When replacing the CE module, carefully check the Ethernet MAC
address on the module label to assure it matches the infuser barcode.

Note: Replacing the CE module does not change the existing biomed settings.
To replace the CE module, see Figure 7-3, Rear View of the Infuser, and Figure 7-4,
CE Module Replacement, then proceed as follows:
1. Press [ON/OFF] to turn off the infuser, and disconnect the device from AC power.
2. Carefully set the infuser face down.
3. Using the Phillips screwdriver, remove the two 4-40 screws from the CE module.
4. Carefully pull the assembly away from the infuser.

Note: When removing the CE module, note the placement guides where the
peripheral PWA rests.
5. Install the replacement CE module in the exact reverse order of removal.

Note: Verify the peripheral PWA is placed properly between the guides and
fits correctly into the CPU PWA.
To verify successful CE module replacement, perform the PVT in Section 5.2.
Technical Service Manual
7-9
430-95551-001-DRAFT
SECTION 7 REPLACEABLE PARTS AND REPAIRS
VOLUME
CONTROL
KNOB
GREEN
LED
6-32 X 2 1/2
PAN HEAD
SCREW
YELLOW
LED
POLE CLAMP
ASSEMBLY
NURSE
CALL
JACK
RJ45
ETHERNET
CONNECTOR
AC POWER CORD
6-32 X 3 1/4
PAN HEAD
SCREW
05K01043
Figure 7-3.
430-95551-001-DRAFT
Rear View of the infuser
7 - 10
Plum A+ with Hospira MedNet
7.2
REPLACEMENT PROCEDURES
CE MODULE
4-40 x 1/2
PAN HEAD
SCREW (2)
05K01040
Figure 7-4.
Technical Service Manual
CE Module Replacement
7 - 11
430-95551-001-DRAFT

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2005:05:19 17:05:41-07:00
Create Date                     : 2005:05:19 16:48:40-07:00
Page Count                      : 3
About                           : uuid:078a6395-5331-465c-9da7-ed4eb99df230
Producer                        : Acrobat Distiller 6.0.1 (Windows)
Mod Date                        : 2005:05:19 17:05:41-07:00
Creation Date                   : 2005:05:19 16:48:40-07:00
Author                          : cossabd
Creator Tool                    : PScript5.dll Version 5.2
Metadata Date                   : 2005:05:19 17:05:41-07:00
Document ID                     : uuid:4bc5e2e5-43ca-4434-9eb4-35aac3316d56
Format                          : application/pdf
Title                           : sec07.fm
Creator                         : cossabd

EXIF Metadata provided by EXIF.tools