Laird Connectivity PKLR2400 User Manual FCCWARN1

AeroComm Corporation FCCWARN1

FCC RF Exposure Warning ref to correspondence 11623

Copyright Information/FCC User’s Notice
Copyright Copyright © 1999 AEROCOMM, Inc. All rights reserved.
Information The information contained in this manual and the accompanying
software programs are copyrighted and all rights are reserved by
AEROCOMM, Inc. AEROCOMM, Inc. reserves the right to make
periodic modifications of this product without obligation to notify
any person or entity of such revision. Copying, duplicating, selling,
or otherwise distributing any part of this product without the prior
consent of an authorized representative of AEROCOMM, Inc. is
prohibited.
All brands and product names in this publication are registered
trademarks or trademarks of their respective holders.
FCC NOTICE
ANTENNA WARNING
Mfr Model Freq Gain Type Connector Dimensions
1Centurion WXE2400 2.4-2.5 2dBi Omni MMCX <2.25"
2Maxrad MFB24008RPN 2.4-2.5 8dBi Omni R-N-F 17"
3Maxrad BMMG24000MSMARP12' 2.4-2.5 unity Omni-mobile R-SMA-M 1.75"
4Maxrad BMMG24005MSMARP12' 2.4-2.5 5dBi Omni-mobile R-SMA-M 9"
5AeroComm NZH2400 2.4-2.5 1dBi Omni Integrated 1"x0.3"
6Maxrad MP24013TMSMARP12 2.4-2.5 13dBi Panel R-SMA-M 8.7x7.9x1.1
7Maxrad MUF24005M174MSMARP12 2.4-2.5 5dBi Omni-Mobile R-SMA-M 8.75"
8Centurion WXR2400SMRP 2.4-2.5 2dBi Omni R-SMA-M <2.25"
NOTE: R-XX IMPLIES A REVERSE POLARITY CONNECTOR
WARNING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
WARNING: This device has been tested with an MMCX connector with the antennas listed below.
Any antenna not in the following table must be tested to comply with FCC Section 15.203
for unique antenna connectors and Section 15.247 for emissions.
LABELING REQUIREMENTS
RF EXPOSURE
WARNING: The Original Equipment Manufacturer (OEM) must ensure that FCC labeling
requirements are met. This includes a clearly visible label on the outside of the OEM
enclosure specifying the AeroComm FCC identifier , KQL-PKLR2400, for this product
as well as the FCC Notice above.
WARNING TO OEMS: To comply with FCC RF Exposure requirements, the Original Equipment
Manufacturer (OEM) must ensure that Antennas 2, 3, 4, 6 and 7 in the previous table
must be installed and/or configured to operate with a separation distance of 20cm or
more from all persons to satisfy RF Exposure compliance.
The preceding statement must be included as a CAUTION statement in
manuals for products operating with Antennas 2, 3, 4, 6 and 7 in the previous
table to alert users on FCC RF Exposure compliance.

Navigation menu