Laird Connectivity PKLR2400 User Manual FCCWARN3
AeroComm Corporation FCCWARN3
Contents
revised FCC Warning per correspondence 11176
Copyright Information/FCC User’s Notice
Copyright Copyright © 1999 AEROCOMM, Inc. All rights reserved.
Information The information contained in this manual and the accompanying
software programs are copyrighted and all rights are reserved by
AEROCOMM, Inc. AEROCOMM, Inc. reserves the right to make
periodic modifications of this product without obligation to notify
any person or entity of such revision. Copying, duplicating, selling,
or otherwise distributing any part of this product without the prior
consent of an authorized representative of AEROCOMM, Inc. is
prohibited.
All brands and product names in this publication are registered
trademarks or trademarks of their respective holders.
FCC NOTICE
ANTENNA WARNING
Mfr Model Freq Gain Type Connector Dimensions Installation
1Centurion WXE2400 2.4-2.5 2dBi Omni MMCX <2.25" Integrated
2Maxrad MFB24008 2.4-2.5 8dBi Omni N-F 17" Professional
20cm min
3Maxrad BMMG24000MMCX6' 2.4-2.5 unity Omni-mobile MMCX 1.75" Professional
20cm min
4Maxrad BMMG24000RPSMA12' 2.4-2.5 5dBi Omni-mobile R-SMA-M 9" Professional
20cm min
5AeroComm NZH2400 2.4-2.5 1dBi Omni Integrated 1"x0.3" Integrated
6Maxrad MP24013FC 2.4-2.5 13dBi Panel TNC-F 8.7x7.9x1.1 Professional
20cm min
7Maxrad MUF24005 2.4-2.5 5dBi Omni-Mobile R-SMA-M 8.75" Professional
20cm min
8Centurion WXR2400SMRP 2.4-2.5 2dBi Omni R-SMA-M <2.25" User
WARNING: This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
WARNING: This device has been tested with an MMCX connector with the antennas listed below.
For the purpose of FCC RF Exposure Compliance, the Original Equipment Manufacturer
(OEM) must ensure professional installation of Antennas 2, 3, 4, 6 and 7 by signing the
PROFESSIONAL ANTENNA INSTALLATION AGREEEMENT. Any antenna not in the
following table must be tested to comply with FCC Section 15.203 for unique antenna
connectors and Section 15.247 for emissions.
LABELING REQUIREMENTS
RF EXPOSURE
WARNING: The Original Equipment Manufacturer (OEM) must ensure that FCC labeling
requirements are met. This includes a clearly visible label on the outside of the OEM
enclosure specifying the AeroComm FCC identifier for this product as well as the FCC
Notice above.
WARNING: For the purpose of FCC RF Exposure Compliance, the Original Equipment
Manufacturer (OEM) must ensure that Antennas 2, 3, 4, 6 and 7 in the previous table
are professionally installed and that a minimum of 20cm spacing between the user and
antenna is required. The OEM is required to sign the by signing the PROFESSIONAL
ANTENNA INSTALLATION AGREEEMENT.