NEC of America KMP6J1CH Single-Band PCS GSM/ EDGE Phone with Bluetooth User Manual RF warning page N500iS

NEC Corporation of America Single-Band PCS GSM/ EDGE Phone with Bluetooth RF warning page N500iS

Contents

Supplemental Users Manual 1

N500iS SAR/DoC
Radio Frequency (RF) Signals(900/1800MHz)
THIS NEC PHONE (MODEL N500iS) COMPLIES WITH THE EU REQUIREMENTS FOR EXPOSURE
TO RADIO WAVES.
Your mobile phone is a radio transceiver, designed and manufactured not to exceed the SAR* limits** for
exposure to radio-frequency (RF) energy, which SAR* value , when tested for compliance against the
standard was (TBD)W/kg. While there may be differences between the SAR* levels of various phones and
at various positions, they all meet*** the EU requirements for RF exposure.
*The exposure standard for mobile phones employs a unit of measurement known as the Specific
Absorption Rate, or SAR.
**The SAR limit for mobile phones used by the public is 2.0 watts/kilogram (W/kg) averaged over ten
grams of tissue, recommended by The Council of the European Union. The limit incorporates a substantial
margin of safety to give additional protection for the public and to account for any variations in
measurements.
*** Tests for SAR have been conducted using standard operating positions with the phone transmitting at its
highest certified power level in all tested frequency bands. Although the SAR is determined at the highest
certified power level, the actual SAR level of the phone while operating can be well below the maximum
value. This is because the phone is designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a base station antenna, the lower the power
output.
Radio Frequency (RF) Signals(1900MHz)
THIS NEC PHONE (MODEL N500iS) COMPLIES WITH THE USA REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES.
Your wireless phone contains a radio transmitter and receiver. Your NEC phone is designed and
manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission of the U. S. Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for the general population. The guidelines are based
on standards that were developed by independent scientific organizations through periodic and thorough
evaluation of scientific studies.
The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific
Absorption Rate (SAR). The SAR limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted using
standard operating positions accepted by the FCC with the phone transmitting at its highest certified power
level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the
actual SAR level of the phone while operating can be well below the maximum value. This is because the
phone is designed to operate at multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base station antenna, the lower the output.
Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it
does not exceed the limit established by the government- adopted requirement for safe exposure. The tests
are performed on position and locations (for example, at the ear and worn on the body) as required by FCC
for each model. The highest SAR value for this model phone as reported to the FCC when tested for use at
the ear is (TBD) W/ kg, and when worn on the body, is (TBD) W/ kg. (Body- worn measurements differ
among phone models, depending upon available accessories and FCC requirements). While there may be
differences between the SAR levels of various phones and at various positions, they all meet the government
requirement.
* In the United States, the SAR limit for wireless mobile phones used by the public is 1.6 watts/ kg (W/ kg)
averaged over one gram of tissue. SAR values may vary depending upon national reporting requirements
and the network band.
Body- worn Operation
The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels
evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is
on file with the FCC and can be found under the Display Grant section at http:// www. fcc. gov/ oet/ fcid
after search on FCC ID A98－KMP6J1CH.
For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines when used
with a NEC accessory designated for this product or when used with an accessory that contains no metal and
that positions the handset a minimum of 1.5 cm from the body.

Navigation menu