NEC of America KMP6J1CH Single-Band PCS GSM/ EDGE Phone with Bluetooth User Manual prefaceCMP

NEC Corporation of America Single-Band PCS GSM/ EDGE Phone with Bluetooth prefaceCMP

Contents

Supplemental Users Manual 2

ii Emergency Services and Safety Precautions
•Electronic vehicle systems, such as anti-lock brakes, speed
control and fuel injection systems are not normally affected by
radio transmissions. The manufacturer of such equipment can
advise if it is adequately shielded from radio transmissions. If
you suspect vehicle problems caused by radio transmissions,
consult your dealer and do not switch on your phone until it has
been checked by qualified approved installers.
Vehicles Equipped with an Air Bag
An air bag inflates with great force. Do not place objects,
including either installed or portable wireless equipment, in the
area over the air bag or in the air bag deployment area. If in-
vehicle wireless equipment is improperly installed and the air
bag inflates, serious injury could result.
Third Party Equipment
The use of third party equipment, cables or accessories, not
made or authorized by NEC, may invalidate the warranty of your
cellphone and also adversely affect the phone’s operation. For
example use only the NEC mains cable supplied with the AC
charger.
Service
The cellphone, batteries and charger contain no user-
serviceable parts. We recommend that your NEC cellphone is
serviced or repaired by an NEC authorized service centre.
Please contact your Service Provider or NEC for advice.
Non-Ionizing Radiations
The radio equipment shall be connected to the antenna via a
non-radiating cable (e.g. coax).
The antenna shall be mounted in a position such that no part of
the human body will normally rest close to any part of the
antenna unless there is an intervening metallic screen, for
example, the metallic roof.
Use only an antenna that has been specifically designed for your
phone. Use of unauthorized antennas, modifications or
attachments could damage your phone and may violate the
appropriate regulations, causing loss of performance and radio
frequency (RF) energy above the recommended limits.
Efficient Use
For optimum performance with minimum power consumption,
note the following:
•Your phone has the internal antenna. Do not cover part of the
internal antenna of the phone with your hands. This affects call
quality, may cause the phone to operate at a higher power
level than needed and may shorten talk and standby times.
Radio Frequency Energy
Your phone is a low-power radio transmitter and receiver. When
it is turned on, it intermittently receives and transmits radio
frequency (RF) energy (radio waves). The system that handles
the call controls the power level at which the phone transmits.
Exposure to Radio Frequency Energy
Your phone is designed not to exceed the limits for exposure to
RF energy set by national authorities and international health
agencies. * These limits are part of comprehensive guidelines
and establish permitted levels of radio wave exposure for the
general population. The guidelines were developed by
independent scientific organizations such as ICNIRP
(International Commission on Non-Ionizing Radiation
Protection) through periodic and thorough evaluation of
scientific studies. The limits include a substantial safety margin
designed to assure the safety of all persons, regardless of age
and health, and to account for any variations in measurements.
*Examples of radio frequency exposure guidelines and
standards that your phone is designed to conform to:
•ICNIRP, “Guidelines for limiting exposure to time-varying
electric, magnetic, and electromagnetic fields (up to 300 G
Hz)-International Commission on Non-Ionizing Radiation
Protection (ICNIRP)”.
Health Physics, vol. 74. pp, 494-522, April 1998.
•99/519/EC Council Recommendation on the limitation of
exposure to the general public to electromagnetic fields 0 Hz-
300 GHz, Official Journal of the European Communities, July
12,1999.
•ANSI/IEEE C95.1-1992. “Safety levels with respect to human
exposure to radio frequency electromagnetic fields, 3kHz to
300 GHz”. The Institute of Electrical and Electronics Engineers
Inc., New York, 1991.
•FCC Report and Order, ET Docket 93-62, FCC 96-326,
Federal Communications Commission (FCC), August 1996.
•Radio communications (Electromagnetic Radiation Human
Exposure) Standard 2003, Australian Communications Media
Authority.
FCC Notices and information to user
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•Consult the dealer or experienced radio/TV technician for help.
This equipment complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Licenses
•T9® Text Input and the T9 logo are registered trademarks of
Tegic Communication.
“T9 Text Input is licensed under one or more of the following:
U.S. Pat. Nos. 5,187,480, 5,818,437, 5,945,928, 5,953,541,
6,011,554, 6,286,064, 6,307,548, 6,307,549, and 6,636,162,
6,646,573; Australian Pat. Nos. 727539, 746674, and 747901;
Canadian Pat. Nos. 1,331,057, 2,302,595, and 2,227,904;
Japan Pat. No. 3532780, 3492981; United Kingdom Pat. No.
2238414B; Hong Kong Standard Pat. No. HK1010924;
Republic of Singapore Pat. No. 51383, 66959, and 71979;
European. Pat. Nos. 0 842 463 (96927260.8), 1 010 057
(98903671.0), 1 018 069 (98950708.2); Republic of Korea Pat.
Nos. KR201211B1 and KR226206B1. People’s Republic of
China Pat. Application Nos. 98802801.8, 98809472.X and
96196739.0; Mexico Pat. No. 208141; Russian Federation
Pat. No. 2206118; and additional patents are pending
worldwide”
•RSA™ is a registered trademark of RSA Data Security Inc.
•OPENWAVE™ is a registered trademark of Openwave
Systems Inc.
•USE OF THIS PRODUCT IN ANY MANNER THAT
COMPLIES WITH THE MPEG-4 VISUAL STANDARD IS
PROHIBITED, EXCEPT FOR USE DIRECTLY RELATED TO
(A) DATA OR INFORMATION ENCODED BY A CONSUMER

Navigation menu