Pepperl Fuchs MVI Cordless, single voltage identification system User Manual Appendix

Appendix

IDENT-M System V

Appendix

Subject to reasonable modifications due to technical advances Copyright Pepperl+Fuchs, Printed in Germany

Pepperl+Fuchs Group Tel.: Germany (062107 76-0 USA (330) 4 25 35 35 Singapore 7 79 90 91 Internet http://www/pepperl-fuchs.com

Additional Information

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instruction manual, may cause harmful interference to

radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his own expense.

Any modifications to this device not expressly approved by the party responsible for FCC related

compliance testing could void the user’s authority to operate the system.

The FFC equipment authorizations has been granted for a system comprised of the following

components:

MVI-D2-2HRX Controller

MVH2000-F15 Antenna

MVC-60-xxxK Data Carrier

Connection between the MVI-D2-2HRX and the MVH2000-F15 is established via the

connection cable that is an integral part of the Antenna. If longer distances are to be

covered the shielded cables must be used.

Pepperl+Fuchs strongly suggest using the accessory cables MVK-xx.