Salto Systems S L WRDBK BLE capable wall RFID card reader User Manual Note

Salto Systems S.L BLE capable wall RFID card reader Users Manual Note

Users Manual_Note

FCC Compliance Statements(FCCID: UKCAE9, UKCAE9W, UKCL90, UKCG90, UKCRPOE, UKCNRF, UKCA9XX, UKCA9XW, UKCCLAYIQ, UKCABXW, UKCABXX, UKCWRDBK)This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.Canadian Compliance Statement(IC: 10088A-AE9, 10088A-AE9W, 10088A-L90, 10088A-G90, 10088A-RPOE, 10088A-NRF, 10088A-A9XX, 10088A-A9XW, 10088A-CLAYIQ, 10088A-ABXW, 10088A-ABXX, 10088A-WRDBK)This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to thefollowing two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Distance between 10088A-CLAYIQ and human body must be higher than 20cm. Distance entre le 10088A-CLAYIQ et le corps humain doit être supérieure à 20 cm.EU Compliance Statement(Products: All Salto Systems S.L. products with RFID/Wireless capability)EN Hereby, Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), declares that this access control equipment is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC (R&TEE). You will be able to find a copy of the original declaration of conformity at the following Internet address: http://www.saltosystems.com/certificate
ES Por medio de la presente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain) declara que este equipo de control de accesos cumple con los requisitos esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva 1999/5/CE (R&TEE). Podrá encontrar una copia de la declaración de conformidad original en la siguiente dirección de internet: http://www.saltosystems.com/certificateFR Par la présente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain) déclare que l’appareil équipement pour le con trôle d’accès est conforme aux exigences essentielles et aux autres dispositions pertinentes de la directive 1999/5/CE (R&TEE). Vous pouvez télécharger une copie de la déclaration de conformité originale à travers l’adresse suivante: http://www.saltosystems.com/certificateDE Hiermit erklärt Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), dass sich das Gerät Zutrittskontrollgeräte in Übereinstimmung mit den grundlegenden Anforderungen und den übrigen einschlägigen Bestimmungen der Richtlinie 1999/5/EG (R&TEE) befindet. Eine Kopie der originalen Konformitätserklärung finden Sie auf der folgenden Internetseite: http://www.saltosystems.com/certificateNL Hierbij verklaart Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain)dat het toestel toegangscontroleapparatuur in overeenstemming is met de essentiële eisen en de andere relevante bepalingen van richtlijn 1999/5/EG (R&TEE). u kunt een kopie van de originele verklaring van overeenstemming vinden op het volgende internetadres: http://www.saltosystems.com/certificateEU Compliance Statement(Products: All Salto Systems S.L. products without RFID/Wireless capability)EN Hereby, Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), declares that this access control equipment is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/ EC (EMC) and Directive 2006/95/EC (Electrical Safety). You will be able to find a copy of the original declaration of conformity at the following Internet address: http://www.saltosystems.com/certificateES Por medio de la presente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain) declara que este equipo de control de accesos cumple con los requisitos esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva 2004/108/CE (EMC) y la Directiva 2006/95/CE (Seguridad Eléctrica). Podrá encontrar una copia de la declaración de conformidad original en la siguiente dirección de internet: http://www.saltosystems.com/certificateFR Par la présente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain) déclare que l’appareil équipement pour le contrôle d’accès est conforme aux exigences essentielles et aux autres dispositions pertinentes de la directive 2004/108/CE, 2006/95/CE. Vous pouvez télécharger une copie de la déclaration de conformité originale à travers l’adresse suivante: http://www.saltosystems.com/certificate
DE Hiermit erklärt Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), dass sich das Gerät Zutrittskontrollgeräte in Übereinstimmung mit den grundlegenden Anforderungen und den übrigen einschlägigen Bestimmungen der Richtlinie 2004/108/EG, 2006/95/EG befindet. Eine Kopie der originalen Konformitätserklärung finden Sie auf derfolgenden Internetseite: http://www.saltosystems.com/certificateNL Hierbij verklaart Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain)dat het toestel toegangscontroleapparatuur in overeenstemming is met de essentiële eisen en de andere relevante bepalingen van richtlijn 2004/108/EG, 2006/95/EG. ukunt een kopie van de originele verklaring van overeenstemming vinden op het volgende internetadres: http://www.saltosystems.com/certificateElectrical WarningsCaution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.Recommended batteries:Duracell Plus Power AAA (MN2400)Simply Duracell AAA (MN2400)Varta High Energy AAA (04903)Varta Longlife AAA (04103)Varta Industrial AAA (04003)Simply Duracell AA (MN1500)Varta High Energy AA (04906)Duracell Plus Power AA (MN1500)Varta Industrial AA (04006)Varta Longlife AA (04106)Varta Professional Lithium CR2 (6206)Duracell Ultra CR2 Lithium (DLCR2)Mechanical WarningsIn order to confirm the correct operation of this electronic device, Salto recommends using it in combination with a lock destined for that use (door mass, frequency of use, fire door, etc) and that is ingood operational conditions. The SALTO product should be treated with care during the installation process to avoid any aggressive contact that may damage the unit. It may be necessary to loosen the trims mounting during installation. Do not bring the device into contact with oil, paints or acids. Do not paint the door with the mortise lock or electronic device already mounted on the door. CLEANING THE ELECTRONIC DEVICE: a damp cloth with mild soapy water can be used. Never use abrasive soaps or sprays. For best performance, stainless steel should be cleaned regularly. Legal WarningsSALTO shall not be liable for any losses, personal damages or claims arising from, or in connection with the incorrect installation of the cylinders/lockers and/or improper programming that may result blocked entry and/or exit.Note that when the door is closed without the lock having been already programmed, the lock will automatically lock and can only be opened with a Portable Programing Device (PPD). If you have questions or doubts on this, please contact your authorized SALTO supplier. In accordance with the SALTO SYSTEMS LIMITED WARRANTY, the warranty does not cover product failures due to repairs,
modifications or product manipulations performed by anyone other than authorized SALTO dealers orpersonnel. Likewise, the warranty is also made null and void if the inner electromechanical structure is in any way manipulated (for instance, loosening the screws) by anyone other than SALTO personnel.

Navigation menu