Symbol Technologies DM4046 VoIP Phone using 802.11b User Manual 72 51346 01RevB p65

Symbol Technologies Inc VoIP Phone using 802.11b 72 51346 01RevB p65

Contents

Addendum

Hearing Aid Compatibility
This product is marked HAC showing compliance with the
applicable requirements of FCC Part 68 and CS03-Part 5.
Radio Frequency Interference
Requirements for Home or Office Use
This device has been tested and found to comply with the limits
for a Class B digital device pursuant to Part 15 of the Federal
Communications Commissions (FCC) Rules and Regulation.
These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a residential environment. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If the equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit different
from that which the receiver is connected.
Radio Frequency Interference
Requirements-Canada
This Class B digital apparatus meets the requirements of the
Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la Classe B respecte toutes les
exigences du Reglement sur le Materiél Brouilleur du Canada.
FCC RF Exposure Guidelines
To comply with RF safety requirements use the specific
belt clip. All other belt clips should be avoided and
may not comply with RF safety requirements. The
FCC has granted an Equipment Authorization for
NetVision phones with all reported Specific Absorption Rate
(SAR) levels evaluated as in compliance with the FCC RF
emission guidelines. SAR information on NetVision phones is on
file with the FCC and can be found under the Display Grant
section of http://www.fcc.gove/oet/fccid.
European Economic Area
The European variant is intended for use throughout the
European Economic area, however authorization for use
restricted as follows:
European standards dictate maximum radiated transmit
power of 100 mW, EIRP and frequency range 2.400 -
2.4835 GHz
France, the equipment is to be restricted to the 2.4465 -
2.4835 GHz frequency range
Belgium outside, the equipment is to be restricted to the
2.460 - 2.4835 GHz frequency range
Operation in Italy requires a user license.
Hereby, Symbol Technologies, Inc., declares that this
product is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
A Declaration of Conformity may be obtained from
http://www2.symbol.com/doc/.
Laser Devices
(Only applies to Data Phone-4046)
Symbol products using lasers comply with US 21 CFR1040.10,
Subchapter J and IEC825/EN 60 825 (or IEC825-1/EN
60-825-1, depending on the date of manufacture). The laser
classification is marked on one of the labels on the product.
Class 1 Laser devices are not considered to be hazardous when
used for their intended purpose. The following statement is
required to comply with US and international regulations:
Use of controls, adjustments or performance
of procedures other than those specified herein
may result in hazardous visible or invisible laser
light exposure.
Class 2 laser scanners use a low power, visible light diode.
As with any very bright light source, such as the sun, the user
should avoid staring directly into the light beam. Momentary
exposure to a Class 2 laser is not known to be harmful.
Samples of Laser Warning Labels
CAUTION: LASER LIGHT WHEN OPEN. DO NOT STARE INTO BEAM.
ATTENTION - LUMIERE LASER EN CAS D'OUVERTURE NE PAS REGARDER DANS LE FAISCEAU.
VORSICHT - LASERLICHT, WENN ABDECKUNG GOFFNET. NICHT IN DEN STRAHL BLICKEN.
LASER LIGHT - DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
LASERLICHT-NICHT IN DEN STRAHL BLICKEN
LASER KLASSE 2
LUMIERE LASER - NE PAS REGARDER DANS LE FAISCEAU
APPARIEL A LASER CLASS 2
630 - 680 nm. 1mw
LASER LIGHT DO NOT STARE INTO BEAM
630 - 680nm LASER 1.0mW MAX OUTPUT
CLASS II LASER PRODUCT
Customer Support
Symbol Technologies provides its customers with prompt and
accurate customer support. Use the Symbol Support Center as
the primary contact for any technical problem, question or
support issue involving Symbol products. If the Symbol
Customer Support specialists cannot solve a problem, access
to all technical disciplines within Symbol becomes available
for further assistance and support. Symbol Customer Support
responds to calls by email, telephone or fax within the time
limits set forth in individual contractual agreements. When
contacting Symbol Customer Support, please provide the
following information:
serial number (MAC address) of unit
part number or product name.
North American Contacts
Inside North America, contact Symbol at:
Symbol Technologies, Inc.
One Symbol Plaza
Holtsville, New York 11742-1300
Telephone: 1-631-738-2400 / 1-800-SCAN 234
Fax: 1-631-738-5990
Symbol Support Center:
Telephone: 1-800-653-5350
Fax: (631) 563-5410
Email: support@symbol.com
International Contacts
Outside North America, contact Symbol at:
Symbol Technologies Technical Support
12 Oaklands Park
Berkshire, RG41 2FD, United Kingdom
Tel: 011-44-118-945-7000 or 1-631-738-2400 ext. 6213
Product Information and Documentation
Documentation for NetVision Products is available online at
http://www.symbol.com/services/downloads/nvdoclist.html.
NetVision Phone®
Regulatory Specifications
Regulatory Compliance
Symbol RF products are designed to be compliant with the rules
and regulations in the locations into which they are sold and
will be labeled as required. The majority of Symbol RF devices
are type approved and do not require the user to obtain license
or authorization before using the equipment. Any changes or
modifications to Symbol Technologies equipment not expressly
approved by Symbol Technologies could void the user’s
authority to operate the equipment.
Applying the Regulatory
Country Stamp
A regulatory label is applied in the battery compartment of
the NetVision Phone. The regulatory label signifies that the
NetVision Phone is approved for use in the following countries:
United States
• Canada
• Australia
Japan (approval pending)
Mexico (approval pending)
• Europe
Austria, Belgium, Croatia, Denmark, Estonia, Finland,
France, Germany, Greece, Iceland, Ireland, Italy,
Liechtenstein, Luxembourg, Netherlands, Norway, Portugal,
Spain, Sweden, Switzerland, United Kingdom.
For approved countries other than those listed above, a sheet of
adhesive country stamps may be enclosed within the NetVision
Phone package.
To Apply the Country Stamp:
1. Peel the stamp appropriate to the country where the
NetVision Phone is used.
2. Apply the country stamp in the space provided on the
regulatory label located in the battery compartment.
Operation of the device without a regulatory label or
the correct country stamp is illegal.
Copyright
Copyright © 2001 by Symbol Technologies, Inc. All rights reserved.
No part of this publication may be modified or adapted in any way, for any
purposes without permission in writing from Symbol Technologies, Inc. (Symbol).
The material in this documentis subject to change without notice. Symbol reserves
the right to make changes to any product to improve reliability, function, or
design. No license is granted, either expressly or by implication, estoppel,
or otherwise under any Symbol Technologies, Inc., intellectual property rights.
An implied license only exists for equipment, circuits, and subsystems contained
in Symbol products.
Symbol, the Symbol logo and Spectrum24 are registered trademarks
of Symbol Technologies, Inc. Other product names mentioned in this manual may
be trademarks or registered trademark of their respective companies and are
hereby acknowledged. IBM is a registered trademark of International Business
Machine Corporation. Microsoft, Windows, and Windows NT are registered
trademarks of Microsoft Corporation.
Patents
This product is covered by one or more of the following U.S. and foreign Patents:
U.S. Patent No.
4,496,831; 4,593,186; 4,603,262; 4,607,156; 4,652,750; 4,673,805;
4,736,095; 4,758,717; 4,760,248; 4,806,742; 4,816,660; 4,845,350;
4,896,026; 4,897,532; 4,923,281; 4,933,538; 4,992,717; 5,015,833;
5,017,765; 5,021,641; 5,029,183; 5,047,617; 5,103,461; 5,113,445;
5,130,520; 5,140,144; 5,142,550; 5,149,950; 5,157,687; 5,168,148;
5,168,149; 5,180,904; 5,216,232; 5,229,591; 5,230,088; 5,235,167;
5,243,655; 5,247,162; 5,250,791; 5,250,792; 5,260,553; 5,262,627;
5,262,628; 5,266,787; 5,278,398; 5,280,162; 5,280,163; 5,280,164;
5,280,498; 5,304,786; 5,304,788; 5,306,900; 5,321,246; 5,324,924;
5,337,361; 5,367,151; 5,373,148; 5,378,882; 5,396,053; 5,396,055;
5,399,846; 5,408,081; 5,410,139; 5,410,140; 5,412,198; 5,418,812;
5,420,411; 5,436,440; 5,444,231; 5,449,891; 5,449,893; 5,468,949;
5,471,042; 5,478,998; 5,479,000; 5,479,002; 5,479,441; 5,504,322;
5,519,577; 5,528,621; 5,532,469; 5,543,610; 5,545,889; 5,552,592;
5,557,093; 5,578,810; 5,581,070; 5,589,679; 5,589,680; 5,608,202;
5,612,531; 5,619,028; 5,627,359; 5,637,852; 5,664,229; 5,668,803;
5,675,139; 5,693,929; 5,698,835; 5,705,800; 5,714,746; 5,723,851;
5,734,152; 5,734,153; 5,742,043; 5,745,794; 5,754,587; 5,762,516;
5,763,863; 5,767,500; 5,789,728; 5,789,731; 5,808,287; 5,811,785;
5,811,787; 5,815,811; 5,821,519; 5,821,520; 5,823,812; 5,828,050;
5,848,064; 5,850,078; 5,861,615; 5,874,720; 5,875,415; 5,900,617;
5,902,989; 5,907,146; 5,912,450; 5,914,478; 5,917,173; 5,920,059;
5,923,025; 5,929,420; 5,945,658; 5,945,659; 5,946,194; 5,959,285;
6,002,918; 6,021,947; 6,031,830; 6,036,098; 6,047,892; 6,050,491;
6,053,413; 6,056,200; 6,065,678; 6,067,297; 6,068,190; 6,082,621;
6,084,528; 6,088,482; 6,092,725; 6,101,483; 6,102,293; 6,104,620;
6,114,712; 6,115,678; 6,119,944; 6,123,265; 6,131,814; 6,138,180;
6,142,379; 6,172,478; 6,176,428; 6,178,426; 6,186,400; 6,188,681;
6,209,788; 6,216,951; 6,220,514; 6,243,447; 6,244,513; 6,247,647;
6,308,061; 6,250,551; 6,295,031; D305,885; D341,584; D344,501;
D359,483; D362,453; D363,700; D363,918; D370,478; D383,124;
D391,250; D405,077; D406,581; D414,171; D414,172; D418,500;
D419,548; D423,468; D424,035; D430,158; D430,159; D431,562;
D436,104.
Invention No. 55,358; 62,539; 69,060; 69,187 (Taiwan); No. 1,601,796;
1,907,875; 1,955,269 (Japan); European Patent 367,299; 414,281; 367,300;
367,298; UK 2,072,832; France 81/03938; Italy 1,138,713
Symbol Technologies, Inc.
One Symbol Plaza
Holtsville, NY
11742-1300
*72-51346-01*
72-51346-01
Revision B

Navigation menu