TOSHIBA TEC Singapore S-0601 Dot Printer User Manual 6
TOSHIBA TEC Singapore Pte Ltd Dot Printer Users Manual 6
Contents
- 1. Users Manual 1
- 2. Users Manual 2
- 3. Users Manual 3
- 4. Users Manual 4
- 5. Users Manual 5
- 6. Users Manual 6
- 7. Users Manual 7
- 8. Users Manual 8
- 9. Users Manual 9
- 10. Users Manual 10
- 11. Users Manual 11
- 12. Users Manual 12
- 13. Users Manual 13
- 14. Users Manual 14
- 15. Users Manual 15
- 16. Users Manual 16
- 17. Users Manual 17
- 18. Users Manual 18
Users Manual 6
Positioning the Paper Stack Place the stack of continuous forms paper as shown in the picture below. Side View Continuous Form Paper Stack Loading Continuous Forms (Push Tractor) This section explains how to use continuous forms with a push tractor at rear (or bottom, depending on printer orientation). Paper is loaded and adjusted via pushbuttons. Forms may be advanced to tear off feature by operator or by host. To load continuous forms paper: 1. Make sure that the printer is turned on. Remove any single-sheet paper from the printer. 2. If necessary, readjust the Print Gap lever for continuous forms. (See the section âAdjusting for Paper Thicknessâ earlier in this chapter.) 3. Move the paper select lever backward to Continuous Paper position. Rear of Printer Continuous Paper Select Lever Single Sheet Front of Printer NOTE: For improved viewing of tractors, you may move the Paper Support to the full-up (Position 3) position. After loading the paper, move it back to the full-down (Position 1) position.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Page Count : 2 Producer : GNU Ghostscript 7.06 Title : Microsoft Word - Ch-2-4 Paper Handling Rev C2_b.doc Creator : PScript5.dll Version 5.2 Create Date : 4/4/2006 13:30:8 Author : 2328EXIF Metadata provided by EXIF.tools