Traxxas LP TRX1018 Traxxas Link wireless module User Manual 2

Traxxas LP Traxxas Link wireless module Users Manual 2

Users Manual-2

10 • TRAXXASGoPro® Camera and accessories not includedCAPTURING VIDEOFilm ModeThe transmitter will always power up in Film Mode. Film Mode is the easiest to fly (see “Controlling Āton” on page 7 for flight control instructions).Install the included landing gear and fixed camera mount to the Āton; then, use your GoPro® or other action camera and accessories (not included)* to capture aerial video.IMPORTANT: Consult local laws and ordinances before installing and operating any type of photograph-capable or video recording device on this model. WARNING: To prevent radio interference and loss of control, always disable Wi-Fi on your GoPro® or other action camera (if so equipped) BEFORE flying the Āton.WARNING: Some GoPro® cameras, specifically the Hero 3 and Hero 4 series with LCD screen, are known to produce radio frequency emissions that could interfere with Aton’s ability to acquire GPS satellite communications. The Āton is equipped with shielding to help protect it from these radio frequency emissions. Use caution with these cameras and test in a safe area to be sure Āton is acquiring GPS satellites and setting a Return to Home location when these cameras are attached, powered on, and recording video. DO NOT operate Āton with these cameras if you are not connected to GPS (four green LEDs on the Status Bar).1. LANDING GEAR INSTALLATIONUse the included 2.6x8mm screws to mount the front and rear landing gear to the helicopter.2. CAMERA BRACKET INSTALLATIONAttach the fixed camera mount to the front landing gear by aligning the tabs. Slide the mount toward the rear of the helicopter until the tabs snap into place.Bottom View of Camera BracketTabsTabsFINAL ASSEMBLY

Navigation menu