ZTE VICKI Wireless Netbook User Manual 00 C DC for XP

ZTE Corporation Wireless Netbook 00 C DC for XP

user manual pt8

43Installing Memory ModulePowered on the notebook, you will verify whethermemory capacity increases or not.Turn on the notebook.Click [Start], click [All Programs] → [Accessories]→ [System Tools] → [System Information].Each system information item is showed in “SystemInformation” window after click [System Information]. Verify the value that indicates in the window.321Confirm the Memory Installed Notice When the value of the memory indicated doesnot increase, please verify whether memory iswell installed.
Health and safety information Radio Frequency (RF) Energy This notebook meets the government’s requirements for exposure to radio waves. This notebook is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government: The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted using standard operating positions accepted by the FCC with the notebook transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the notebook while operating can be well below the maximum value. This is because the notebook is designed to operate at multiple power levels so as to use only the poser required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. The highest SAR value for the model notebook as reported to the FCC is 0.201 W/kg in Body-worn measurements While there may be differences between the SAR levels of various notebook and at various positions, they all meet the government requirement.
The FCC has granted an Equipment Authorization for this model notebook with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID: Q78-VICKI FCC Compliance NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help. WarningChangesormodificationsmadetothisequipmentnotexpresslyapprovedbyZTEforcompliancecouldvoidtheuser'sauthoritytooperatetheequipment.

Navigation menu