ZTE VICKI Wireless Netbook User Manual 00 C DC for XP
ZTE Corporation Wireless Netbook 00 C DC for XP
ZTE >
Contents
user manual pt8
43
Installing Memory Module
Powered on the notebook, you will verify whether
memory capacity increases or not.
Turn on the notebook.
Click [Start], click [All Programs] → [Accessories]
→ [System Tools] → [System Information].
Each system information item is showed in “System
Information” window after click [System Information].
Verify the value that indicates in the window.
3
2
1
Confirm the Memory Installed
Notice
When the value of the memory indicated does
not increase, please verify whether memory is
well installed.
Health and safety information
Radio Frequency (RF) Energy
This notebook meets the government’s requirements for
exposure to radio waves.
This notebook is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set
by the Federal Communications Commission of the U.S.
Government:
The exposure standard for wireless mobile phones employs a
unit of measurement known as the Specific Absorption Rate, or
SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for
SAR are conducted using standard operating positions
accepted by the FCC with the notebook transmitting at its
highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power
level, the actual SAR level of the notebook while operating can
be well below the maximum value. This is because the
notebook is designed to operate at multiple power levels so as
to use only the poser required to reach the network. In
general, the closer you are to a wireless base station antenna,
the lower the power output.
The highest SAR value for the model notebook as reported to
the FCC is 0.201 W/kg in Body-worn measurements
While there may be differences between the SAR levels of
various notebook and at various positions, they all meet the
government requirement.
The FCC has granted an Equipment Authorization for this
model notebook with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines. SAR
information on this model phone is on file with the FCC and can
be found under the Display Grant section of
http://www.fcc.gov/oet/fccid after searching on FCC ID:
Q78-VICKI
FCC Compliance
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for
help.
Warning
Changesormodificationsmadetothis
equipmentnotexpresslyapprovedbyZTEfor
compliancecouldvoidtheuser'sauthorityto
operatetheequipment.