Siemens Canada Siemens Milltronics Process Instruments LR250 SITRANS LR250 Level Probing Radar User Manual LR250OpenAirDeclarationx
Siemens Canada Ltd. - Siemens Milltronics Process Instruments SITRANS LR250 Level Probing Radar LR250OpenAirDeclarationx
Contents
User Manual_Addendum
Siemens Canada Limited
Siemens Milltronics Process Instruments
1954 Technology Drive, P.O. Box 4225
Peterborough, Ontario
K9J 7B1 / Canada
Tel.: (705) 745-2431
Fax: (705) 741-0466
www.siemens.com/sensorsystems
Declaration to FCC Rule 15.256
For open air installations, the following conditions must be observed:
The following warning note is applicable to Section 2.1.3, FCC Conformity in place of the current content.
Affected manuals are:
A5E32220602 (SITRANS LR250 Hart/mA) (page 14)
A5E32221386 (SITRANS LR250 PROFIBUS) (page 14)
A5E32221411 (SITRANS LR250 Foundation Fieldbus) (page 13)
A5E32337683 (SITRANS LR260 Hart) (page 1)
A5E32337685 (SITRANS LR260 PA) (page 1)
WARNING
Changes or modifications not expressly approved by Siemens Milltronics could void the user’s authority to operate
the equipment.
Notes
This device has been tested and found to comply with the limits Class B digital device part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This device has also been tested and found to comply with the limits §15.256, Subpart C-Intentional
radiators, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment.
This device generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications, in
which case the user will be required to correct the interference at his/her own expense.
This device is certified to measure levels in fixed or mobile enclosed tanks made from metal, concrete
or materials with similar RF attenuating properties.
Devices equipped with the 3 inch or 4 inch antennas may be used to measure levels in open air
environments or outside enclosed tanks, subject to the following conditions:
o Devices shall be installed and maintained to ensure a vertically downward orientation of the
transmit antenna’s main beam.
o Devices shall be installed only at fixed locations. Devices shall not operate while being moved
or while inside a moving container.
o Hand-held applications and residential use are prohibited.
Peterborough, June 30, 2014