TOSHIBA TEC Singapore S-0601 Dot Printer User Manual 4

TOSHIBA TEC Singapore Pte Ltd Dot Printer Users Manual 4

Users Manual 4

Rear Front Left Side View 1. Power Switch 2. Cover Latch (to secure top cover) 3. Forms Tractors (to hold and feed continuous forms) 4. Paper Guides (to guide single sheets) 5. Paper Exit Slot and Tear Edge 6. Top Cover – Rear 7. Single Sheet Tray (Shown in down Position) Bottom View 8. Interface Connectors (or Wireless Adapters if installed)  Vertical Position Bottom View 
Operations of the Control Panel This section summarizes status indications and operations of the control panel in Normal mode. For details on Set-Up mode, see Chapter 4, “Using Set-Up Mode.” Normal mode operation includes everyday operations, such as paper handling, font selection, macro selection, and protocol selection. The first table lists basic states represented by the Ready and Fault indicators. The second table lists Normal mode operations and required user response. Operations are listed by functions. Basic States of the Printer Indicator Status Printer Status Ready On The printer is ready for printing or The printer is receiving or printing data. Blinking The printer is not ready and holds printing data. Off The printer is not ready and it does not hold printing data. Fault On The printer is out of paper. Blinking slowly The printer has detected an operational error: paper jam, interface error, carriage error, paper unloading error, etc. Blinking fast The printer detected diagnostic errors at power-up.
Operation Required Conditions *1 Required Action Ready Printing *2 Fault Load continuous forms paper — Not printing On Press FF/LOAD. Load single sheet paper — Not printing On Paper is automatically detected and advanced (auto-loading) when it is first inserted. In this mode, if the FF button is pushed, the inserted sheet will be ejected from the printer and the Fault LED will light, indicating paper out condition. Feed paper a page — Not printing Off Press FF/LOAD. Advance perforation to tear — Not printing Off Press READY. bar Eject single-sheet paper — Not printing Off Press FF/LOAD. The Fault LED will light, indicating a paper out condition. Unload continuous-forms — Not printing Off Press Park. paper *3 Pause printing On Printing Off Press READY Resume printing Blinking Not printing Off Press READY Resume printing after a fault Off Not printing On Clear error and press READY. Resume printing after paper Off Not printing On Load paper. out Place printer in Ready state Off Not printing Off Press READY Place printer in pause state On — Off Press READY Enter Normal mode N/A N/A N/A Turn power on without pressing any buttons Printing test N/A N/A N/A Turn power on while pressing FF/LOAD button. Operation Required Conditions *1 Required Action
Ready Printing *2 Fault Enter Top-of-Form Adjustment mode—Not printing Off Press SETUP/EXIT and ALT. Use the adjustment temporarily Off — Off Press ALT-NEXT. Use the adjustment permanently Off — Off Press SETUP/EXIT. Clear the adjustment Off — Off Press ALT-PREVIOUS. Enter Set-Up mode N/A N/A N/A Turn power on while pressing SETUP/EXIT. Move cursor to select Off Not printing Off Press NEXT or PREVIOUS button. a Set-Up Function or Value Move cursor to select Off Not printing Off Press NEXT or PREVIOUS button. a Set-Up Option Select a Set-Up Function or Value Off Not printing Off Press ALT-NEXT or ALT-PREVIOUS button. Select a Set-Up Value and Off Not printing Off Press SETUP/EXIT. move cursor to SAVE&EXIT Clear software-detected errors — — Blinking Press SETUP/EXIT Initialize the printer — — — Turn power off and on again. *1 In Normal mode operation, all buttons except READY are inactive in the Busy state in which the printer is receiving or printing data. *2 Not printing includes the following situations: the printer is ready and awaiting data, or the READY button is pressed and the printer is awaiting data, or the READY button is pressed during printing. *3 This operation is available in the rear-feeding push-tractor mode.

Navigation menu