Ubiquiti LBE5ACG2 LBE-5AC-Gen2, LBE-5AC-Omni-Gen2 User Manual LiteBeam LBE 5AC Gen2 Quick Start Guide

Quick Start Guide_Part 2

Hardware Installation

The LiteBeam AC was designed for outdoor use and quick

mounting on a pole.

1. Assemble the antenna reflector by attaching the

SideReflector Panels to the Center Reflector Panel:

a. Insert the heads of the two mounting studs on the

Center Reflector Panel into the large opening of the

slotted holes of the Side Reflector Panel.

b. Slide the Side Reflector Panel down until the top edges

of the panels align. The Side Reflector Panel is captured

when both heads of the mounting studs are positioned

over the narrow opening of the slotted holes.

c. Repeat the assembly for the other Side Reflector Panel.

2. Hold the reflector assembly by hand (do not use a tabletop

or flat surface) and insert the Feed Receiver into the

reflector assembly to secure the panels:

a. Align the arrows on the Center Reflector Panel and the

Feed Receiver, and insert both edges of the Side Reflector

Panels and Center Reflector Panels into the Securing Arms

of the Feed Receiver.

b. Insert the Feed Receiver into the Center Reflector Panel by

pressing the top and bottom snap hooks into the slots

of the Center Reflector Panel.

WARNING: Do not install the Feed Receiver into the

reflector assembly by pushing down onto a tabletop or

other flat surface as this can deform the panels. Hold the

reflector assembly by hand.

c. For additional support, there are eight machine screws

that secure the SideReflector Panels to the antenna

assembly.

3. Insert the Antenna Feed into the Feed Receiver until the feed

locks into place.

4. Turn the Port Cover counterclockwise to reveal the

EthernetPort on the Antenna Feed.