dresden elektronik ingenieurtechnik MEGA23M12 Lightport User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3419217
Application ID	S16+ehvr/gEjdPsx5YohLw==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	167.73kB (2096659 bits)
Date Submitted	2017-06-09 00:00:00
Date Available	2017-11-10 00:00:00
Creation Date	2017-04-07 11:58:07
Producing Software	Adobe PDF Library 15.0
Document Lastmod	2017-04-07 11:58:08
Document Title	Users Manual
Document Creator	Adobe InDesign CC 2015 (Windows)

max 10m.
12 VDC
DMX
Masterspot 2 Track
LA N
Quick Installation Guide
Connect the Invisua Lightport to your local network
router (with internet access) via the supplied LAN cable.
(Recommended maximum distance Lightport-fixtures:
10m. line of sight)
www.invisua.com
1 2
12 VDC
DMX
LA N
Verify that the second LED is ON to confirm internet
connection. (Blinking indicates having an IP address
obtained, full ON indicates internet connection)
Power the Invisua Lightport via the supplied 12V
power supply.
Check document “Network and Hardware
recommendations” in case the second LED does not light
up. (http://main.invisua.com/en/downloads/)
4628
4626
It is recommended to position the fixtures ordered
by serial number. In that way the fixture sequence in
Invisua Create will be identical.
Mount all the Invisua Masterspot 2 Track fixtures on
your track.
On
Of f
1 2
On
5sec
Press button #1 on the Lightport for 5 sec. to initiate
commissioning of your system. (lamp indicator LED on the
Lightport will turn ON)
Of f
 ithin 30 sec. after pressing button #2, turn the Masterspot
2 Track fixtures OFF and ON again, by disconnecting and
reconnecting the 230V power.
8
Please wait approx. 2 minutes. All fixtures should
light up purple, to confirm that they have been
discovered by the Lightport.
All fixtures should turn green for 1 sec and after some
time, give white light. This confirms that the fixtures are
on the right unique communication channel.
If not all fixtures have turned green for 1 sec
go back to step 6.
If not all fixtures have turned purple go back
to step 6, but if step 8 was successful, you can
skip step 7 and 8
10
11
1 2
By going to my.invisua.com, one of the pre-stored light
scenes can be activated. With the color-picker the
fixture(s) can be set to any white or RGB color instantly.
(Make sure you are connected to the same network as
the Invisua Lightport)
After all fixtures have lit up purple, testing your
setup can be done by pressing button #2 on the
Lightport, to toggle between some default light
scenes.
12
Please visit www.create.invisua.com (via pc or tablet)
to create your first light scenes!
(We strongly recommend you to follow the Invisua Create
Tutorial once logged in to make yourself familiar with the
system)
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices).
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)
(2)
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
(if mobile device (generally 20 cm distance) is applicable, MPE calculation)
“This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter”.
v. 1.02

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Language                        : en-US
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.6-c123 79.158978, 2016/02/13-01:11:19
Create Date                     : 2017:04:07 11:58:07+02:00
Metadata Date                   : 2017:04:07 11:58:08+02:00
Modify Date                     : 2017:04:07 11:58:08+02:00
Creator Tool                    : Adobe InDesign CC 2015 (Windows)
Instance ID                     : uuid:bd22b7f9-d8d5-49a1-b556-34f5bd8f4eef
Original Document ID            : xmp.did:AD56BFB93E206811808390276894E723
Document ID                     : xmp.id:70dc1bcf-9337-8741-90a7-9ff1dd36361f
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:49c6af9b-0593-aa4d-bd57-8329f5a58901
Derived From Document ID        : xmp.did:fc1d99a5-71fd-c949-b264-08101e33dd1f
Derived From Original Document ID: xmp.did:AD56BFB93E206811808390276894E723
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 2015 (Windows)
History Changed                 : /
History When                    : 2017:04:07 11:58:07+02:00
Format                          : application/pdf
Producer                        : Adobe PDF Library 15.0
Trapped                         : False
Page Count                      : 2
Creator                         : Adobe InDesign CC 2015 (Windows)

EXIF Metadata provided by EXIF.tools