VTech Telecommunications 80-6101-00 Cordless Telephone System with BT Enabled Base User Manual Pages from pages 48 last

Part 15 statement

Appendix

FCC Part 15

This equipment has been tested and found to comply with the requirements

for a Class B digital device under Part 15 of the Federal Communications

Commission (FCC) rules. These requirements are intended to provide

reasonable protection against harmful interference in a residential instal-

lation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular instal-

lation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by

the party responsible for compliance could void the user’s authority to

operate the equipment.

To ensure safety of users, the FCC has established criteria for the

amount of radio frequency energy that can be safely absorbed by a

user or bystander according to the intended usage of the product. This

product has been tested and found to comply with the FCC criteria. The

handset may be safely held against the ear of the user. The telephone

base shall be installed and used such that parts of the user’s body

other than the hands are maintained at a distance of approximately 20

cm (8 inches) or more. If you choose to use a clipping device, please

make sure to only use the supplied AT&T belt clip.