Askey Computer WLL220C 2.4GHz/5GHz Mini-PCI Card User Manual

Askey Computer Corp 2.4GHz/5GHz Mini-PCI Card Users Manual

NB Users Manual Chap 4

Expanding Memory
Memory
Memory
Installing a Memory Module
Removing a Memory Module
Your notebook has 128MB/256MB/512MB DDR-266 installed. You can
extend the memory up to 1GB. The available memory modules are
128MB, 256MB and 512MB.
Read through the information below carefully before you begin. If you
don't feel completely confident installing a memory module yourself,
contact your notebook dealer.
For problems with memory, see Chapter 7, Troubleshooting.
Avoid touching the connectors on the memory module or your
notebook. Grease or dirt on the connectors can cause memory access
problems.
Static electricity can damage the memory module. Before you handle
the module, touch a grounded metal surface to discharge any static
electricity you may have.
Before purchasing new memory for your notebook, check with your
computer dealer for recommended memory modules.
Installing a Memory Module
Removing a Memory Module
Top
Installing a Memory Module
If you are adding a memory module after you have started to use the
computer, begin at step 1. Otherwise, skip to step 3.
1. If the computer is on, click Start.
2. In the Shut Down Windows dialog box, select Shut Down -> OK.
3. Remove all cables connected to the computer.
第 1 頁，共 3 頁Expanding Memory
2003/8/15
file://C:\WINDOWS\TEMP\~hh59A2.htm
4. Close the display panel and turn the computer upside down.
5. Remove the battery.
6. Remove the screw securing the memory module cover, then remove the
the cover.
7. Hold the memory module by its edges at 45 degrees, so that the
goldfinger connector bar fits into the rear slot, then push and press the
module gently into the socket.
8. Position the memory module cover on the computer and secure it with
the screw.
9. Turn your notebook right side up.
10. Reconnect any cables you disconnected.
11. Turn on your notebook and verify that it correctly recognizes the amount
amount of memory currently installed in the computer
Top
Removing a Memory Module
1. If the computer is on, click Start.
2. In the Shut Down Windows dialog box, select Shut Down -> OK.
3. Remove all cables connected to the computer.
4. Close the display panel and turn the computer upside down.
5. Remove the battery.
6. Remove the screw securing the memory module cover, then remove the
the cover.
7. Release the memory module by gently pushing the latches on both
sides of the memory socket outward. The module will then pop up.
第 2 頁，共 3 頁Expanding Memory
2003/8/15
file://C:\WINDOWS\TEMP\~hh59A2.htm
8. Remove the memory module.
9. Position the memory module cover and secure it with the screw.
10. Turn your notebook right side up.
11. Reconnect any cables you disconnected.
12. Turn on your notebook and verify that it correctly recognizes the amount
amount of memory installed.
Top
第 3 頁，共 3 頁Expanding Memory
2003/8/15
file://C:\WINDOWS\TEMP\~hh59A2.htm

Navigation menu