Askey Computer WLL220C 2.4GHz/5GHz Mini-PCI Card User Manual

Askey Computer Corp 2.4GHz/5GHz Mini-PCI Card Users Manual

NB Users Manual Warning

Safety Instructions
Use the following safety guidelines to help protect yourself and your
computer.
When Using Your Computer
CAUTION: Do not operate your portable computer for an extended
period of time with the base resting directly on your body. With
extended operation, heat can potentially build up in the base.
Allowing sustained contact with the skin could cause discomfort
or, eventually, a burn.
Do not attempt to service the computer yourself. Always follow
installation instructions closely.
Do not carry a battery in your pocket, purse, or other container where
metal objects (such as car keys) could short-circuit the battery
terminals. The resulting excessive current flow can cause extremely
high temperatures and may result in damage from burns.
Be sure that nothing rests on your AC adapter's power cable and that
the cable is not located where it can be tripped over or stepped on.
Place the AC adapter in a ventilated area, such as a desk top or on the
floor, when you use it to run the computer or to charge the battery. Do
not cover the AC adapter with papers or other items that will reduce
cooling; also, do not use the AC adapter while it is inside a carrying
case.
Do not push objects into air vents or openings of your computer. Doing
so can cause fire or electric shock by shorting out interior components.
Use only the AC adapter and batteries that are approved for use with
this computer. Use of another type of battery or AC adapter may risk
fire or explosion.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type battery recommended by
by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
Before you connect the computer to a power source, ensure that the
voltage rating of the AC adapter matches that of the available power
source.
- 115 V/60 Hz in most of North and South America and some Far
Eastern countries such as South Korea and Taiwan.
- 100 V/50 Hz in eastern Japan and 100 V/60Hz in western Japan.
- 230 V/50 Hz in most of Europe, the Middle East, and the Far East.
If you use an extension cable with your AC adapter, ensure that the
total ampere rating of the products plugged in to the extension cable
does not exceed the ampere rating of the extension cable.
第 1 頁，共 3 頁Safety Instructions
2003/8/15
file://C:\WINDOWS\TEMP\~hh1A1.htm
To remove power from the computer, turn it off, remove the battery, and
and disconnect the AC adapter from the electrical outlet.
To help avoid the potential hazard of electric shock, do not connect or
disconnect any cables or perform maintenance or reconfiguration of this
this product during an electrical storm.
Do not dispose of batteries in a fire. They may explode. Check with
local authorities for disposal instructions.
When setting up the computer for work, place it on a level surface.
When traveling, do not check the computer as baggage. You can put
your computer through an X-ray security machine, but never put your
computer through a metal detector. If you have the computer checked
by hand, be sure to have a charged battery available in case you are
asked to turn on the computer.
When traveling with the hard drive removed from the computer, wrap
the drive in a non-conducting material, such as cloth or paper. If you
have the drive checked by hand, be ready to install the drive in the
computer. Your can put the hard drive through an X-ray security
machine, but never put the drive through a metal detector.
When traveling, do not place the computer in overhead storage
compartments where it could slide around. Do not drop your computer
or subject it to other mechanical shocks.
Protect your computer, battery, and hard drive from environmental
hazards such as dirt, dust, food, liquids, temperature extremes, and
overexposure to sunlight.
When you move your computer between environments with very
different temperature and/or humidity ranges, condensation may form
on or within the computer. To avoid damaging the computer, allow
sufficient time for the moisture to evaporate before using the computer.
NOTICE: When taking the computer from low-temperature
conditions into a warmer environment or from high-temperature
conditions into a cooler environment, allow the computer to
acclimate to room temperature before turning on power.
When you disconnect a cable, pull on its connector or on its strain relief
relief loop, not on the cable itself. As you pull out the connector, keep it
evenly aligned to avoid bending any connector pins. Also, before you
connect a cable make sure both connectors are correctly oriented and
aligned.
Before you clean your computer, turn if off, unplug it from its power
source, and remove the battery.
Handle components with care. Hold a component such as a memory
module by its edges, not its pins.
CAUTION: When using your telephone equipment, basic safety
precautions should always be followed to reduce the risk of fire,
electric shock and injury to persons, including the following:
Do not use this product near water, for example, near a bathtub,
washing bowl, kitchen sink or laundry tub, in a wet basement or near a
swimming pool.
Avoid using a telephone (other than a cordless type) during an electrical
第 2 頁，共 3 頁Safety Instructions
2003/8/15
file://C:\WINDOWS\TEMP\~hh1A1.htm
electrical storm. There may be a remote risk of electric shock from
lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
Use only the power cord indicated in this manual.
Federal Communication Commission Interference Statement
IMPORTANT NOTE
Federal Communication Commission Interference
Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
Top
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for
for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance.
For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to
indoor environment, and the antenna of this device must be integral.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Top
第 3 頁，共 3 頁Safety Instructions
2003/8/15
file://C:\WINDOWS\TEMP\~hh1A1.htm

Navigation menu