Broadcom BRCM1017 Broadcom 802.11ag WLAN Mini PCI Card User Manual 578 100 097C

Broadcom Corporation Broadcom 802.11ag WLAN Mini PCI Card 578 100 097C

Host Manual 2

578-100-097 Revision C Page 1 of 2
*578-100-097C*
*578-100-097C*
Compliance Statement Insert
Device Name: Data Collection Computer Model Number: CV60
The responsible party for the compliance of this device is: Intermec Technologies Corporation
6001 36
th
Avenue West
Everett, WA 98203
USA
This product conforms to the following approvals. The user(s) of this product are cautioned to use accessories and peripherals approved by
Intermec Technologies Corporation. The use of accessories other than those recommended, or changes to this product that are not approved by
Intermec Technologies Corporation, may void the compliance of this product and may result in the loss of the users authority to operate the
equipment.
FCC Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the radio of television receiving antenna.
• Increase the separation between the computer equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
• Consult the dealer or an experienced radio television technician for help.
Canadian Digital Apparatus Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
This device contains radio frequency transmitters approved by the Federal Communications Commission under FCC ID: EHABTM210 and
FCC ID: QDS-BRCM1017 .
WARNING: Per the FCC radio frequency (RF) exposure requirements,
(1) Antennas must be supplied and installed as recommended by Intermec Technologies Corporation to insure compliance to RF exposure
requirements. The integral antennas approved for use are not to be serviced by the user.
(2) When installing and using Intermec CV60, a 20-cm (8-inch) passing distance must be maintained from any body part of the user or nearby
persons and the antennas at the top of the unit. The antenna area must not be touched during transmitter operation.
(3) RF safety requirements mandate this device cannot be co-located with other transmitters.
578-100-097 Revision C Page 2 of 2
*578-100-097C*
*578-100-097C*
DECLARATION OF CONFORMITY
(According to ISO/IEC Guide 22 and EN 45014)
THE PRODUCT HEREWITH COMPLIES WITH THE REQUIREMENTS OF :
THE LOW-VOLTAGE DIRECTIVE 73/23/EEC.
THE EMC DIRECTIVE 89/336/EEC.
THE R&TTE DIRECTIVE 1999/05/EC.
Manufacturer’s Name: European Representative:
Intermec Technologies Corporation Intermec International Incorporated
6001 36th Avenue West Reading Int’l Business Park
Everett, WA 98203 Basingstoke Road
Reading, Berkshire
RG2 6DD United Kingdom
Declares that the product listed below:
Product Type: ITE/Residential, Commercial, and Light Industrial
Product Name: Data Collection Computer
Model Number: CV60 Product Options: ALL
Beginning Serial Number: All Date Issued: July 06, 2006
Conforms to the following product specifications:
Safety: IEC 60950-1 / EN 60950-1
EMC: EN 55022 : 1998 / CISPR Publication 22 : 1997, Class B Limits and Methods
EN 55024 : 1998 (CISPR 24) Information Technology Equipment – Immunity Characteristics –
Limits and Methods of Measurement
EN61000-3-2 : 2000 – Harmonic Current Emissions
EN61000-3-3 : 1995 – Voltage Fluctuation and Flicker
Radio: ETSI EN 300 328-2
ETSI EN 301 489-17
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s)
and Standard(s).
Company Official: Michael Abel Position: Vice President
Signature: Signed Copy on File Date: _06-July-2006_______
European Contact: Intermec International Incorporated, Reading Int’l Business Park, Basingstoke Road, Reading,
Berkshire,
RG2 6DD United Kingdom; Phone: +44 118 923 0800; Fax +44 118 923 0801

Navigation menu