Psion WLPC24H User Manual 80440 Safety

Psion Inc 80440 Safety

Teklogix 9150 Wireless Gateway User Manual Cautions to Users

Teklogix 9150 Wireless Gateway User Manual viiCAUTION TO USERSThis equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC rules. These limits are designedto provide reasonable protection against harmful interference when the equipmentis operated in a commercial environment. This equipment generates, uses andcan radiate radio frequency energy and, if not installed and used in accordancewith the instruction manual, may cause harmful interference to radio communica-tions. Operation of this equipment in a residential area is likely to cause harmfulinterference, in which case the user is required to correct the interference at personalexpense. The transmitters supplied are not to be operated within the frequency band406 - 406.1 MHz.Changes or modifications not expressly approved by Teklogix Inc. can void theuser’s authority to operate the equipment.An unshielded plug or cable may cause radiation interference. All peripheral devicesmust be used with properly shielded interface cables and external filters as required.The shield must be connected directly to the chassis of the peripheral device.
Safety Summaryviii Teklogix 9150 Wireless Gateway User ManualIMPORTANT SAFETY INSTRUCTIONSThis safety information is for the protection of both operating and service personnel.DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHEREOperating Teklogix equipment where explosive gas is present may result inan explosion.DO NOT REMOVE COVERS OR OPEN ENCLOSURESTo avoid injury, the equipment covers and enclosures should only beremoved by qualified service personnel. Do not operate the equipment with-out the covers and enclosures properly installed.DO NOT HOLD ANTENNATo avoid discomfort due to the local heating effect of radio frequencyenergy, do not touch the antenna when a 9150 is transmitting.CONNECTION TO OUTDOOR ANTENNAOutdoor antenna to be earthed in accordance with International StandardEN 50083-1 (1993), “Cabled Distribution Systems for Television andSound Signals - Safety Requirements”.ANSCHLUß AN ANTENNENNANLAGENAußenantennennanlagen müssen nach nationalen oder internationalenNormen (z.B. EN50083-1(1993) geerdet werden.

Navigation menu